MEP1040 units in parallel

[Dogger]

I need to parallel 2 MEP1040s. I’m looking for advice on wiring the two units. My thoughts are wire one unit to the other then wire one of the two units to my master panel. Any flaws or problems with this method? Thanks in advance for any assistance!!

 

[kloppk]

Do you have the paralleling cable?

 

[Dogger]

Do you have the paralleling cable?

Yes, I have the cable.

 

[Guyfang]

Have you read the TM's?

 

[Dogger]

Have you read the TM's?

It’s been at least a year since I’ve looked at them, I plan on revisiting as soon as possible.

 

[Dogger]

It’s been at least a year since I’ve looked at them, I plan on revisiting as soon as possible.

If I remember correctly the TM’s had info on running with or without switch box for parallel however not much detail on actual wiring setup. Again I will revisit the TM’s instructions especially once I am in the process of getting the units synced together.

 

[FarmingSmallKubota]

not my video but here you go. Please read the TM could get expensive and dangerous otherwise

 

[Dogger]

not my video but here you go. Please read the TM could get expensive and dangerous otherwise

Thanks for sharing this video, I still would like some feedback on how I initially stated that I was planning on wiring for my setup.

 

[Guyfang]

Well, send a PM to Daybreak. Member here, he made the video. If you cant send a PM, tell me.

Break: Please change your location to the state you live in, IAW the forum rules.

 

[Dogger]

Well, send a PM to Daybreak. Member here, he made the video. If you cant send a PM, tell me.

Break: Please change your location to the state you live in, IAW the forum rules.

Well received, PM sent to Daybreak…Thanks for the response as well as informing me about the forum rules. I’ll update my location info.

 

[Guyfang]

Thanks!!