Read through a lot of the posts already about overload. Just looking to get some perspective. I was running a couple of RVs with three air conditioners total. Seemed to be running at about 60% load consistently. Ran like this for three days. Yesterday, started getting overloads after running about 15 minutes. No rhyme or reason. Also, the % Load Meter would not register even after resetting and then restarting genset. Outside temps were in the low 90's. Generator sits in a shipping container and runs with the doors open. New to the forum and not as technical as most here.
1. Could this have been an anomoly due to temperature?
2. Is there anything beyond the reset for the warnings on the front panel that I should do?
3. I ordered some contact cleaner and will exercise and clean the AM/VM switch once I head back up to the location where the genset is stored.
Thanks for any insight.
1. Could this have been an anomoly due to temperature?
2. Is there anything beyond the reset for the warnings on the front panel that I should do?
3. I ordered some contact cleaner and will exercise and clean the AM/VM switch once I head back up to the location where the genset is stored.
Thanks for any insight.