halftrack
Active member
- 1,018
- 11
- 38
- Location
- New Orleans, LA
This is what happens to the back of a new Humvee when it stops too short in front of a MTVR.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
MTVR vs Humvee
- Thread starter halftrack
- Start date
- 4,763
- 1,162
- 113
- Location
- Gaithersburg, MD
RE: MVTR vs Humvee
Cool pics, Jason. I bet the MTVR was barely scratched. Interestingly, though, the HMMWV actually came through it fairly well considering the body is aluminum. I suppose I should wait to say that until you tell us how fast the MTVR was going!
Cool pics, Jason. I bet the MTVR was barely scratched. Interestingly, though, the HMMWV actually came through it fairly well considering the body is aluminum. I suppose I should wait to say that until you tell us how fast the MTVR was going!
El_Guapo
Member
- 128
- 0
- 16
- Location
- Sandy Springs, GA
RE: MVTR vs Humvee
I'd buy that for a dollar
I'd buy that for a dollar
halftrack
Active member
- 1,018
- 11
- 38
- Location
- New Orleans, LA
They said the vehicle is to be turned into DRMO. I don't know how true that is. The MTVR literally had no scratches on it. It supposedly was only going 10 mph or less. The driver's head of the Humvee hit the windshield and broke it. Driver was OK becuase rule is when Marines drive tactical vehiles, kevlar must be worn.
bbf
Member
- 461
- 0
- 16
- Location
- port st lucie fl
that left a mark
Jetnoise400
Member
- 238
- 0
- 16
- Location
- Sparks, NV
No worries, it'll buff out.
kinetichotshot
New member
- 143
- 0
- 0
- Location
- Aggieland, TX
Ahh, its nothing... just a flesh wound...
- 10,350
- 75
- 48
- Location
- Meadows of Dan, Virginia
The HMMWV must have stopped very suddenly for the driver to be thrown forward....or am I missing something...again?
El_Guapo
Member
- 128
- 0
- 16
- Location
- Sandy Springs, GA
http://youtube.com/watch?v=p5ACDk8MIso It's a Mazda test but you can see that after the acceleration of the impact the car decelerates faster than the driver. I would think teh harder he had his brakes on from stopping short the more likely this would happen. He must have been tall.
benni72
Member
- 89
- 0
- 6
- Location
- Rockwall, TX
don't sweat it dude my dad has a great set of tools!
- 10,350
- 75
- 48
- Location
- Meadows of Dan, Virginia
Yeah, that must be one of the biggest problems on the interstate when you drive a truck with limited top speed in traffic, a semi is on an on-ramp ahead and you have no place to go except to slow down and hope it will avoid what happened here. The semi rarily has no choice but to keep going.....blackdog said:This happened on a merge... semi truck ran into this one.
Been there, avoided the above many times over thousands of miles on the interstates. Plan for those on-ramps ahead!