Soko121
New member
- 2
- 0
- 0
- Location
- Georgetown Texas
Hello All,
bought first Mule, had sat for 5 years with new crate engine before that. Pulled tank, lines, fuel pump, carb, plugs, etc. new carb, flushed and cleaned system, went through 3 new fuel pumps to get one that was not bad !!!, cleaned plugs, removed mag, disassembled and cleaned,removed pull start, added electrical system etc....finally , pre oiled ,it cranked and ran, set idle all good, went to put in gear and clutch would not disengage. With pedal all the way ( and adjusted ), would not go in gear , grinding as clutch not working. Pulled engine, cable, throw out bearing, and return springs seem fine, pulled pressure plate, cleaned surfaces of plate, and flywheel, also cleaned clutch disk, which looks quite good. Put all back together and......same issue with engine not running and mule in gear with clutch depressed, will not roll...what am I missing ??
bought first Mule, had sat for 5 years with new crate engine before that. Pulled tank, lines, fuel pump, carb, plugs, etc. new carb, flushed and cleaned system, went through 3 new fuel pumps to get one that was not bad !!!, cleaned plugs, removed mag, disassembled and cleaned,removed pull start, added electrical system etc....finally , pre oiled ,it cranked and ran, set idle all good, went to put in gear and clutch would not disengage. With pedal all the way ( and adjusted ), would not go in gear , grinding as clutch not working. Pulled engine, cable, throw out bearing, and return springs seem fine, pulled pressure plate, cleaned surfaces of plate, and flywheel, also cleaned clutch disk, which looks quite good. Put all back together and......same issue with engine not running and mule in gear with clutch depressed, will not roll...what am I missing ??