-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
My first Deuce
- Thread starter sac
- Start date
18operator
Well-known member
- 1,093
- 1,855
- 113
- Location
- Seville, Ohio
That's a good looking truck! Hope it give you many years of enjoyment!
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 757
- 113
- Location
- Cincy Ohio
I know guys that hook LEDs up to the black out lights so no switch or relay is needed. Some will hook a switch to the transmission rod that pops out when you put it in reverse.
FloridaAKM
Well-known member
- 2,699
- 392
- 83
- Location
- Gainesville, Florida
If you want to see where you are backing into, a single or set of 24v lamp fixtures of your choice, attached to a switch/relay will let you see what you are running into. Gimpy stated some good ideas also. My idea was to get a lamp fixture here & wire it into the system, with a switch in the dash, until I got a light kit from a GL auction to install.
FloridaAKM
Well-known member
- 2,699
- 392
- 83
- Location
- Gainesville, Florida
No manners again,sorry, welcome to the Green Iron Laughing Academy. Pull up a chair & see what you can learn. That truck of yours looks like mine except for all the white stuff around it! Nice looking truck, hope it gives you loads of fun!
- 907
- 317
- 63
- Location
- southeast Indiana
Welcome to the site from another new deuce owner.
Another Ahab
Well-known member
- 18,007
- 4,579
- 113
- Location
- Alexandria, VA
I've seen more than one Thread on the back-up light issue; try a good search.
And welcome from Virginia.
And welcome from Virginia.
- 2,811
- 41
- 38
- Location
- Mt. Eden, KY
Everyone in Iowa is getting M35s... Welcome from Kentucky, check/search the classifieds, a member here puts together a neat back up light switch kit. You add the light of your choice.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 757
- 113
- Location
- Cincy Ohio
If your looking for lights, I have a BUNCH of 50watt floods in 24v in the classifieds, or PM for more info.
machinist75
Member
- 777
- 7
- 18
- Location
- Murphy, TEXAS
Peashooter used to make a part that attached to the shaft that comes out the front of the transmission when you put it in reverse. He may still have a few left, send him a pm.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 757
- 113
- Location
- Cincy Ohio
I'm pretty sure Ziggy has a bunch of switches too.
ageregunner
Active member
- 705
- 88
- 28
- Location
- Breinigsville, PA
Welcome from PA. I just acquired my first duece in September. It is a real hoot to drive and the hobby is very addicting.
Jeepsinker
Well-known member
- 5,399
- 457
- 83
- Location
- Dry Creek, Louisiana
Yes peashooter made or makes a kit with an adapter and switch included. A very clean setup it is indeed. The shaft that actuated it is the sprag engagement shaft that comes out of the rear of the transmission case near the top on the passenger side.
m109a2
Member
- 624
- 1
- 18
- Location
- lake charles la.
You want to go with 395s I would not do so,go with a 11
My local Tractor Supply Company has a pair of LED floods for $40. They are univolt (9-32 volts). I have put LED floods under the bed of my trucks, pointing to the sides and back. On my deuce, they are about centered over the pivot between the two rear axles, up high under the bed near the frame. Very inconspicuous that way, when not in use.
I have them on a toggle switch that has power at all times so I can leave them on with the truck off. They work great as area lights that way, as well as for backing up. The light to the sides helps when backing up through my property gates.
I have them on a toggle switch that has power at all times so I can leave them on with the truck off. They work great as area lights that way, as well as for backing up. The light to the sides helps when backing up through my property gates.
Thanks that sounds like what I was looking for. I see in your signature you have a 12 volt alt. as well, where did you get that.
- 18,551
- 5,926
- 113
Welcome aboard 
Find a bunk, stow your gear, and prepare to get underway
As someone already suggested, the SEARCH button is your friend. Beware of some of the old farts around here, though. You may want to be careful about picking up any fumbled soap bars in the shower, if you know what I mean. Actually, there are many here with invaluable knowledge and a willingness to share it. We truly welcome you aboard.
<--- I just got to use this for the very first time. Thanks, Drew (?) for my personalized Smiley!
Find a bunk, stow your gear, and prepare to get underway
As someone already suggested, the SEARCH button is your friend. Beware of some of the old farts around here, though. You may want to be careful about picking up any fumbled soap bars in the shower, if you know what I mean. Actually, there are many here with invaluable knowledge and a willingness to share it. We truly welcome you aboard.
<--- I just got to use this for the very first time. Thanks, Drew (?) for my personalized Smiley!
Last edited: