Need a bad 60 amp generator

[emmado22]

All,
I need a bad 60 amp generator.. I busted the top ear off of my perfectly running oen..... Let me know what you have and the cost.

The EARS must be OK. Internally fried is fine!

Leece-Neville Division
60 Amps
Ordnance No. 10929868
Type No. A0013002AE OR A0013002AD

Thanks!

Mark

 

[jwaller]

I got one. lemme see if I can find a good local one to replace it's location on my truck and it's yours

 

[Armada]

Same thing happened to mine. It broke through the outside half of the mounting hole. There were air pockets in the casting that created a weak point. I was able to use a bolt and nut with washers to remedy it. There is not very much of a load put on it anyway.

 

[VBsurfer]

All,
I need a bad 60 amp generator.. I busted the top ear off of my perfectly running oen..... Let me know what you have and the cost.

The EARS must be OK. Internally fried is fine!

Leece-Neville Division
60 Amps
Ordnance No. 10929868
Type No. A0013002AE OR A0013002AD

Thanks!

Mark

I see you have the same one I do. Just got my deuce and it doesn't run but putting it back together. I have mine wired up but not sure where the male/female military plug goes on the alternator. Here is a picture of how I have it wired up. Hopefully you can tell me which post it goes on. I don't have the cover for it either and not sure where to get that.

 

[G744]

That alt is a different make than Prestolite, so the connections aren't the same as pictured above.

The 14ga wire carries the "on" command from the master switch, and needs to be connected to the Alt via one of the small screw terminals. (NOT goround).

DG

 

[VBsurfer]

That alt is a different make than Prestolite, so the connections aren't the same as pictured above.

The 14ga wire carries the "on" command from the master switch, and needs to be connected to the Alt via one of the small screw terminals. (NOT goround).

DG

Yes it is one of those two posts just not sure which one. I think it is the first one, but trying to find out to be sure. I think we have the same model though according to these pictures and based on your original description.

 

[G744]

Yours is a Leece-Neville. Most are Prestolite, and they have only one "on" terminal.

I'll have to dig in my manuals to see what goes on your L-N.

DG

 

[VBsurfer]

Yours is a Leece-Neville. Most are Prestolite, and they have only one "on" terminal.

I'll have to dig in my manuals to see what goes on your L-N.

DG

This is as close as someone else sent me to my model, not the best one out there.

 

[G744]

From the TM pix, It looks to be the screw closest to the pulley end.

DG