Need a bolt and some info

[eaw46]

I have been searching around here but no one seems to have this bolt or they are just not intrested in selling ONE. It is the bolt missing in the second picture. Does anyone know a place to get one? I would also be intrested in any info anyone has about the history of this jeep it is now done and I am driving it. Thanks Eddy

 

[emr]

the MVPA has a ton of Jeep vendors in there classifieds that would help U, ...

 

[73m819]

the MVPA has a ton of Jeep vendors in there classifieds that would help U, ...

U is spelled YOU

 

[NDT]

That is a screw and it is the same as a deuce 5 ton GMC etc.

 

[JGBallew]

I have been searching around here but no one seems to have this bolt or they are just not intrested in selling ONE. It is the bolt missing in the second picture. Does anyone know a place to get one? I would also be intrested in any info anyone has about the history of this jeep it is now done and I am driving it. Thanks Eddy

You can kind of fudge that fastener with a panhead slotted and a thin washer centered on the shank and turned down a bit to act as a spacer.

The original screw had a short stepped shoulder that the bushed area rode on. IIRC they were a 1/4"X20 TPI.

Personally I like to use a slightly longer screw and mount a thin wave or Bellville washer under the screw head, because those pivot points always seem to get wallowed out and vibrate.

 

[32r2]

Windshield pivot arm screws

Eddy,go to g503.com.On the home page click on parts,this will take you to Ron Fitzpatricks vintagejeeps.com site.The part number is A2239K for a set of two screws and washers.Cost is eight dollars.They show as in stock.They are listed under the body section.The description is windshield arm pivot screws + spring washers.Hope this helps.