Brad
Member
- 200
- 11
- 18
- Location
- Bolivar, Pa
Looked over the net and can only find full gasket sets. Anyone know of a source for just a valve cover gasket for a GMC 6 cyll, M135?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Need a valve cover gasket........
- Thread starter Brad
- Start date
jasonjc
Well-known member
- 5,326
- 289
- 83
- Location
- Gravette Ar.
If it the same as a 270 ( I think it mite be ) Felpro # VS3460A $13 at Oreileys.
Brad
Member
- 200
- 11
- 18
- Location
- Bolivar, Pa
Looks like that is the correct one at Oreilly's I am picking it up Thursday.
Would you guys use any gaslet shellac or that blue silicone stuff?
The one one it and also another engine I have and took off, neither one had anything like that. This one leaked cause the gaskey pulled out of place and then conformed and warped to the distortion. I think it would never straighten out, that's why I want a new one.
I was thinking of shellacing it to the head only?
Thanks
Would you guys use any gaslet shellac or that blue silicone stuff?
The one one it and also another engine I have and took off, neither one had anything like that. This one leaked cause the gaskey pulled out of place and then conformed and warped to the distortion. I think it would never straighten out, that's why I want a new one.
I was thinking of shellacing it to the head only?
Thanks
DUUANE
Active member
- 403
- 122
- 43
- Location
- Qualicum Beach BC
If i use a gasket adhesive i usually glue it to the valve cover..makes it a lot easier to chip off 10 years later and there is no chance of sending debris down into oil drainback passages.
Brad
Member
- 200
- 11
- 18
- Location
- Bolivar, Pa
yea, that makes more sense, thanks for saving me a lot of trouble.
DUUANE
Active member
- 403
- 122
- 43
- Location
- Qualicum Beach BC
If you clean it really well..use brake clean or laquer thinner then ispropanol as the final wipe you will get a nice bond..if you can resist over torquing the seal youll be able to take the cover on and off a few times before a do-over.. its handy for vehicles that need regular lash adjustments. Or have a half mile long floppy seal with only 4 bolts holding it in.
I remember the first time i took off a valve cover set up that way as a kid.. a little voice in my head says to me.."oh ya..thats cool".. it can be a little rough with rubber seals that are miss shapen.. extra heavy duty contact cement works for those usually. Again wipe the seal and cover with iso as a last step before gluing.
Happy sealing..
I remember the first time i took off a valve cover set up that way as a kid.. a little voice in my head says to me.."oh ya..thats cool".. it can be a little rough with rubber seals that are miss shapen.. extra heavy duty contact cement works for those usually. Again wipe the seal and cover with iso as a last step before gluing.
Happy sealing..