Tanaga
Member
- 50
- 0
- 6
- Location
- Palmer, AK
Well i I thought I did but I may have had my multimeter on the wrong setting. Figuring out how to use that is half the battle.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Need advice with parasitic battery drain
- Thread starter Tanaga
- Start date
Well i I thought I did but I may have had my multimeter on the wrong setting. Figuring out how to use that is half the battle.
Member Tow4 is also selling kits and has a rebuild thread in the stickies
http://www.steelsoldiers.com/showthread.php?146703-CUCV-Alternator-Rebuild
http://www.steelsoldiers.com/showthread.php?146703-CUCV-Alternator-Rebuild
rustystud
Well-known member
- 9,298
- 3,074
- 113
- Location
- Woodinville, Washington
Good price on the kits. I'm a firm believer that if your going to open up your alternator you might as well replace the bearings and brushes and diode pack all at the same time.
redline300
Member
- 48
- 1
- 8
- Location
- Ocala, Florida
What is the normal amp draw on an M1009? I had a parasitic draw. Found it to be the Alternator wires not being connected fully. Since fixing that issue....what is the normal amp draw supposed to be at?
rustystud
Well-known member
- 9,298
- 3,074
- 113
- Location
- Woodinville, Washington
If you have a working radio, then the amp draw should be around 0.03amps to 0.05amps . Any more and your loosing power from something, usually the alternator diodes.
- 1,370
- 960
- 113
- Location
- State College, PA
rustystud
Well-known member
- 9,298
- 3,074
- 113
- Location
- Woodinville, Washington
That's not too bad. Your alternator diodes might be slipping a little current by them, but if you drive it daily you won't notice a thing.