-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Need opinions
- Thread starter sn8ke
- Start date
Cruceno
New member
- 112
- 0
- 0
- Location
- Portsmouth, Virginia
Phew...depends on SOOO many things. Pictures would help in determining a price.
Hainebd
New member
- 520
- 5
- 0
- Location
- Mays Landing, NJ
I paid $1,500 for my 71. Was in bad shape. 3 flats. No lights. Running hot. Tons of rust and rot. I add two gallons of coolant, fixed flats, replaced rear harness, turn signal switch, rebuilt headlight switch, both tail light assemblies and one front turn signal assembly. Then left front wheel falling off, found lock tab torn, replaced bearings and seals and both boots. One wheel cylinder and two sets of seals and bearings, one set of shoes. Flushed brake fluid. Installed complete winch from PTO to winch.
All said and done I would have been better off purchasing a truck in better condition. I think less expensive.
I still have rust, mechanical and electrical to deal with. The bed has dent and rust so I am looking to replace. They are out there.
I also want a crew cab so I have to decided what how to do.
Not sure if this helps but $1,500 to $2,000. I know of a REO dump for $1,200. Basically scrap price.
The big question is what is the truck worth to you. You may have a great reason for wanting to own that truck. Only you can decide the value to you.
in my case I could buy and restore slowly. I would not want to take a nice truck and cut up, so this truck made sense to/for me. My wife saw it and told me to buy so I did.
it is a buyers market. Great deals are around for great trucks.
All said and done I would have been better off purchasing a truck in better condition. I think less expensive.
I still have rust, mechanical and electrical to deal with. The bed has dent and rust so I am looking to replace. They are out there.
I also want a crew cab so I have to decided what how to do.
Not sure if this helps but $1,500 to $2,000. I know of a REO dump for $1,200. Basically scrap price.
The big question is what is the truck worth to you. You may have a great reason for wanting to own that truck. Only you can decide the value to you.
in my case I could buy and restore slowly. I would not want to take a nice truck and cut up, so this truck made sense to/for me. My wife saw it and told me to buy so I did.
it is a buyers market. Great deals are around for great trucks.
Last edited:
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 752
- 113
- Location
- Cincy Ohio
I wouldn't.
Dhallftworth
Member
- 119
- 0
- 16
- Location
- Fort Worth, tx
I would think that it's ok, since you're not actually selling it.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 752
- 113
- Location
- Cincy Ohio
Start at scrap price and go from there. Everyone and their brother thinks just the axles are worth 1500, but every time I get some to sell, I get less than 800. Motor, trans, T-case, seats, doors, etc. Its probably worth more in parts, but scrap price is a good place to start.
Dhallftworth
Member
- 119
- 0
- 16
- Location
- Fort Worth, tx
Does the stuff on the back come with it? It looks to be in fairly good shape
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 752
- 113
- Location
- Cincy Ohio
That doesn't look bad. I'd jump on it, all it needs is a bed.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 752
- 113
- Location
- Cincy Ohio
Whats that trike on the back?! I'd buy that for the right price!
Cruceno
New member
- 112
- 0
- 0
- Location
- Portsmouth, Virginia
Looks in good shape to me. That hard top is a plus in my book
Dhallftworth
Member
- 119
- 0
- 16
- Location
- Fort Worth, tx
It is in mine too.
- 26,246
- 1,177
- 113
- Location
- NY
Try reading the rules(you did agree to them).
wreckerman893
Possum Connoisseur
- 15,627
- 2,041
- 113
- Location
- Akenback acres near Gadsden, AL
With a hard top and without a bed I'd go 900 and never try to start it. If it is a runner and all systems are good (cooling, elec, brakes. wiring, lights) I'd go 1200. Thats about scrap price without a bed. The good deal about no bed is you can put whatever you want on there. I found a nice factory made flatbed at a junkyard and put it on my bobber.