• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

No power in cab except lights

dstang97

Well-known member
1,859
31
48
Location
Clover, SC
Ok a little info for you guys. I needed a new engine and cab wiring harness for my m1028 because PO owner hacked it up. This is the 2nd time I have done this swap. The new/used harness is complete and not hacked. I also took out my steering column and replaced it with a known good one, because the old one had a bad wiper switch. No problem i have done them in the past. Here is where it does not make sense. All of my fusible links look fine and tested them with a light. I have good fuses, and cleaned the grounds and fuse box, I can only get the dash lights to work. Any suggestions? So power is not getting to keyed sources.
 
Last edited:

86m1028

Active member
1,687
17
38
Location
Murphy TEXAS
Ok a little info for you guys. I needed a new engine and cabe wiring harness for my m1028 because PO owner hacked it up. This the 2nd time I have done this swap. The new/used harness is complete and not hacked. I also took out my steering column and replaced it with a known good one, because the old one had a bad wiper switch. No problem i have done them in the past. Here is where it does not make sense. All of my fusible links look fine and tested them with a light. I have good fuses, and cleaned the grounds and fuse box, I can only get the dash lights to work. Any suggestions? So power is not getting to keyed sources.

Check your ignition switch.

Lights arent switched power by key.
 

dstang97

Well-known member
1,859
31
48
Location
Clover, SC
no power in the fuse panel at all except lights. I switched out the column for a known good one. I need to find out what one or ones are the main wires to the panel. I have a hard time reading the manuals. I think the problem is somewhere in the firewall connection.
 
Last edited:

dstang97

Well-known member
1,859
31
48
Location
Clover, SC
Check your ignition switch.

Lights arent switched power by key.
Ok just checked the ignition switch and there is power in the red wires. There are 2. One in the black connector and one in the blue connector. Both are live so I need a switch. Kinda odd both columns do not work.
 

dstang97

Well-known member
1,859
31
48
Location
Clover, SC
I do have one more steering column that came out of my red truck last week i may swap them out real quick.
 

dstang97

Well-known member
1,859
31
48
Location
Clover, SC
Just swapped in another column that just came out of my red truck. It is doing the same thing. I took out my meter and checked all fuses and they are fine. One thing I did notice is when i turn the key to run I loose power at the steering column at the red wires. Does that sound right. It seems it should power up the pink and orange. to go to the heater and engine control????
Please I really need help on this one. I need to get this running asap because it will be snowing soon and this will be a plow truck.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks