• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Old M35 gasser electrical question?

citizensoldier

Active member
3,981
17
38
Location
Northern Michigan. Smelt City
Been stripping off the DNR 12 volt stuff and putting back to original wiring. Its all there except rear tail light harness. I have two wires that were taped off behind the guage plate. #400 and #86.. What do each go to? There is a bare wire on the spider harness but only one?
I see these old ones did not have a tac? Kindof strange.. :shock:
Oh and I dont see any 24 volt breakers anywhere? Was there any like a M37? If so where ? Thanks ahead of time....
 

DDoyle

Well-known member
Supporting Vendor
1,825
80
48
Location
West Tennessee
If no one else answers, I can look the wire numbers up in the morning. OR, if there is a M37 manual on line - those numbers are likely listed in it, and will serve the same function on the M35.

Breaker (s) are under the dash if they are not on the firewall.

Hope this helps,
David
 

citizensoldier

Active member
3,981
17
38
Location
Northern Michigan. Smelt City
Thanks again doc. I do have a wiring diagram from a M37.. Did not know they would be exactly the same. Dont recall a #400 though.. Darn truck is a cherry! Wiring is not cracked or anything. They just pluged the original wiring and ran a new 12 volt one. Not often you find one that has not been all cut up.. :D
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks