pigpen60
Active member
- 681
- 127
- 43
- Location
- foley/missouri
Like it says, I put it on and I find it on the floor in the morning. I reinstall it go for a drive find it in my lap. Ideas?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Old style horn button rubber cover wont stay attached!
- Thread starter pigpen60
- Start date
steelandcanvas
Well-known member
- 6,187
- 85
- 48
- Location
- Southwestern Idaho
Sounds like it may not be seating correctly. Try a little spray silicone on the rubber cover, twist and push as you re-install. Everyone that works on these vehicles should have a can of spray silicone, even if only used to re-couple Packard connectors.
dmetalmiki
Well-known member
- 5,523
- 2,028
- 113
- Location
- London England
"Everyone that works on these vehicles should have a can of spray silicone, even if only used to re-couple Packard connectors".
Roger that, those horn covers are a pain if not fitted in all the way, with silicone or similar.
Roger that, those horn covers are a pain if not fitted in all the way, with silicone or similar.
pigpen60
Active member
- 681
- 127
- 43
- Location
- foley/missouri
Silicone spray, Learn something new. I'll give it a shot, Thank you.
pigpen60
Active member
- 681
- 127
- 43
- Location
- foley/missouri
Well silicone was a big nono. I spritzed it and installed and when my hand came off the cover it was in the floor.