-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Parachute Fails on HMMWV
- Thread starter EdMontana
- Start date
ARYankee
Well-known member
- 1,983
- 33
- 48
- Location
- Benton, AR
Just another demil/scrap alternative. 
- 34,012
- 1,808
- 113
- Location
- GA Mountains
That's just "flat" out wrong.
212sparky
Well-known member
- 1,822
- 38
- 48
- Location
- Monroe/ Ohio
Ran just before delivery, some forklift damage
- 14,254
- 1,720
- 113
- Location
- Dayton, OH
To me it looks like it was deliberately crushed. Where is the body?
Cleveland Iron
Member
- 224
- 1
- 16
- Location
- Independence, OH
Lost that on the second or third bounce...
- 4,762
- 1,154
- 113
- Location
- Gaithersburg, MD
This same thing happened when my brother first joined the 82nd AB. He was a new 2nd LT and was being "schooled" by some Staff Sergeant about the way they do it in the 82nd (I believe my brother told me that he said "stand back, LT, and watch how its done in the 82nd!"). Well, they watched a road grader get dropped out of a C130 (not sure of the plane right now) and the parachute failed to deploy. He told me that you only heard a faint whistling sound and then a loud crash as the loader hit the deck. When they drove over to it, my brother told me the grader had embedded itself in the ground so far that he could literally look over the a** end of it.
- 2,894
- 501
- 113
- Location
- Ft. Bragg, NC
I posted the same on g503, but I'm pretty sure the HMMWV separated from the platform. I think in that picture the HMMWV is actually upside down. the lack of body work tells me that. If they had sand filled crates in there to represent ammo, I would not be surprised if gravity started tugging on that instead.
Fishtail
New member
- 121
- 0
- 0
- Location
- stevens point wisconsin
I'm guesstimating that it landed upside down, and the body was impaled into the ground. Then they threw the chassis back on the platform to transport it.
Scott
Scott
cpf240
Active member
- 1,479
- 5
- 38
- Location
- Free in Northern Idaho
You mean that this is not one of those new flat-pack HMMWVs from Ikea? Some assembly required?
Danger Ranger
New member
- 2,253
- 23
- 0
- Location
- Roland, IA
I wonder if the engine dug itself a hole to China? I bet it gets there one way or another....lol.
wb1895
Member
- 876
- 17
- 18
- Location
- Lexington NC
EUC still required
- 2,868
- 27
- 48
- Location
- Delta, PA.
I guy up the road from me buys alot of military surplus.He has a hmmwv that the chute did not open on.It looks similiar.
jw4x4
Active member
- 1,082
- 5
- 38
- Location
- Dayton, Ohio
If your 'chute doesn't open, you will likely never need one again.
nf6x
Feral Engineer
- 1,630
- 50
- 48
- Location
- Riverside, CA, USA
Who would have guessed that the minimum reducible height is about 18 inches?
nattieleather
Well-known member
- 1,882
- 143
- 63
- Location
- Cleveland, OH
Slap a coat of paint on it and drive it! LOL! What would be more impressive (or hurtfull) would be video of it? I'm off to check Youtube....
papakb
Well-known member
- 2,285
- 1,185
- 113
- Location
- San Jose, Ca
I think that's one of the HMMWVs being sold by Government Liquidation!
Kurt
Kurt
- 1,093
- 146
- 63
- Location
- Los Angeles,Ca
This is one of these new inflatable HMMWV's. It is deflated while in transport then re-inflated once it reach's it's destination.
or
This could be one of those experimental dehydrated HMMWV's, just add water and fluids and it comes back to life.
or
This could be one of those experimental dehydrated HMMWV's, just add water and fluids and it comes back to life.
nf6x
Feral Engineer
- 1,630
- 50
- 48
- Location
- Riverside, CA, USA
"Fluids drained"