chuck-10
New member
- 41
- 0
- 0
- Location
- shippensburg,PA
looking for info on piston sleeve removal and installation.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
piston sleeve removal
- Thread starter chuck-10
- Start date
chuck-10
New member
- 41
- 0
- 0
- Location
- shippensburg,PA
chuck-10
New member
- 41
- 0
- 0
- Location
- shippensburg,PA
thanks for the info,looks like they just slide in with no special tools
clinto
Moderator, wonderful human being & practicing Deuc
Staff member
Administrator
Super Moderator
Steel Soldiers Supporter
Supporting Vendor
- 12,596
- 1,131
- 113
- Location
- Athens, Ga.
Holy crap-you broke it!
kipman
Active member
- 2,514
- 15
- 38
- Location
- Lancaster Ohio
Looks like Stretch broke it.
DieselBob
Active member
- 2,891
- 15
- 38
- Location
- Arnold Maryland
I feel fairly certain that is not the approved method of removal...
RedbeardTheZombieHunter
New member
- 702
- 4
- 0
- Location
- Darrington, Washington.
OUCH! Now I feel like going outside and hugging my deuce! 
saddamsnightmare
Well-known member
- 3,618
- 80
- 48
- Location
- Abilene, Texas
May 9th, 2012.
Now may not be the time to mention this to the OP, BUT there is a special tool kit for pulling Multifuel engine sleeves properly, and they often turn up on EBAY for cheap!
Now may not be the time to mention this to the OP, BUT there is a special tool kit for pulling Multifuel engine sleeves properly, and they often turn up on EBAY for cheap!
- 9,580
- 218
- 63
- Location
- Dickson,TN
I pulled a pan off a deuce that looked just like that recently. That's as far as I got and just pulled the engine. The funny thing is the thing was still running. Knocking hard but still running.
ChuckM
New member
- 55
- 0
- 0
- Location
- Brantley, AL
I once seen an EMD sling a rod out of the side of the block and land next to my feet. It kept running until I shut it down. Engines can run under some abnormal conditions.
- 2,960
- 30
- 48
- Location
- Tiro, Ohio
Yep, looks like my M108 engine. Let us know how the bore looks. Mine blew at idle, and yes, it still ran.
- 9,580
- 218
- 63
- Location
- Dickson,TN
Sounds like there could be a pattern here. I wonder what would cause a sleeve to fall apart like that?
- 14,254
- 1,723
- 113
- Location
- Dayton, OH
Here is Stretch's.
Attachments
spicergear
New member
- 2,307
- 27
- 0
- Location
- Millerstown, PA
Diesels WANT to run...they'll churn and grind themselves into chunks before finally stopping.
- 2,479
- 25
- 38
- Location
- Houston Texas
put it in the freezer overnitght before installing. Keep it as cold as possable untill you install it. When cold they will usall slide right in. Alot less banging if you dont have the right tools