goodguyzy
Active member
- 1,337
- 13
- 38
- Location
- medford oregon
Whoever has a cdl is welcome to have a turn, of Scott can go first. Unless I can register it as a motor home then your 95 year old GP can drive.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
PNW Info Thread!
- Thread starter wsucougarx
- Start date
srodocker
Well-known member
- 6,549
- 69
- 48
- Location
- Lacey, Washington
They probably turn better then our internationals at work lol
- 144
- 0
- 16
- Location
- Graham, WA
Ordkhntr, congratulations on your first piece of green(or tan) iron. Also, welcome to the addiction!
mobileauto2000
Member
- 718
- 9
- 18
- Location
- Springfield Or
Welcome RJ. I am in Springfield, nice to have someone close by. Get that thing ready for camping by July so you can go to the PNW-2014-Sixth Annual Chehalis River Valley M/V Convoy & Campout. I missed this year because my truck broke down. But I'm going next year. Its a lot of fun!
goodguyzy
Active member
- 1,337
- 13
- 38
- Location
- medford oregon
Welcome RJ
buggyman
New member
- 34
- -1
- 0
- Location
- Ontario, OR
Hi guys, I'm Paul Kingsbury and live in Bend, OR.
I've got a 923A2 and lots of big boy toys too. I have a Fab and Repair shop also and would love sharing and talking.
Happy Trails!
I've got a 923A2 and lots of big boy toys too. I have a Fab and Repair shop also and would love sharing and talking.
Happy Trails!
thanks everyone,
It should be great for camping. I have labs that I take to field trials and they take up the bed of the truck so now I will have a place for all the other stuff.
I started looking around and asking around and am beginning to wonder.......will I be able to tow this thing back home with my F150? Its suppose to weigh 2700lbs, and I have towed way more than that before. I have a pintle hitch and the magnetic mount trailer lights......am I missing something ????
It should be great for camping. I have labs that I take to field trials and they take up the bed of the truck so now I will have a place for all the other stuff.
I started looking around and asking around and am beginning to wonder.......will I be able to tow this thing back home with my F150? Its suppose to weigh 2700lbs, and I have towed way more than that before. I have a pintle hitch and the magnetic mount trailer lights......am I missing something ????
srodocker
Well-known member
- 6,549
- 69
- 48
- Location
- Lacey, Washington
buggyman wish you lived closer im going to start getting quotes on a project....
Wolfen
Active member
- 944
- 154
- 43
- Location
- Woodburn Oregon
I also wished you lived closer Buggyman. I would talk to you about finishing up my WC54.
goodguyzy
Active member
- 1,337
- 13
- 38
- Location
- medford oregon
You will tow it fine with a 1/2 ton.thanks everyone,
It should be great for camping. I have labs that I take to field trials and they take up the bed of the truck so now I will have a place for all the other stuff.
I started looking around and asking around and am beginning to wonder.......will I be able to tow this thing back home with my F150? Its suppose to weigh 2700lbs, and I have towed way more than that before. I have a pintle hitch and the magnetic mount trailer lights......am I missing something ????
goodguyzy
Active member
- 1,337
- 13
- 38
- Location
- medford oregon
Welcome Paul, woo hoo more oregon members.
buggyman
New member
- 34
- -1
- 0
- Location
- Ontario, OR
You guys are always welcome to come over to some of the worlds best views
)))DrillerSurplus
New member
- 443
- 7
- 0
- Location
- Salt Lake City. UT
They are pretty good about calling back if you leave a voicemail or fax your request in with copy of paid invoice.
Amer-team
Well-known member
- 1,707
- 32
- 48
- Location
- Centralia/WA
So what are you recovering?
manders
Member
- 92
- 0
- 6
- Location
- Spokane Valley, WA
I'm scheduled to pick up a M923 within the next 3-5 days from Ft. Lewis and I'm looking for a recommendation for nearby maintenance/repair shop/guy, preferably within about 3-5 miles, that can do a general maintenance pass, e.g., replace all fluids, battery check, ABS check, tran check, etc.
My plan is to drive it to the repair depot for a sanity check before I drive it the remaining ~70 miles home.
I appreciate the guidance ...
My plan is to drive it to the repair depot for a sanity check before I drive it the remaining ~70 miles home.
I appreciate the guidance ...
hwcurtice
Well-known member
- 1,558
- 35
- 48
- Location
- Moncks Corner, SC
What? And no pre-pictures of your prize?
Fail!
Fail!
manders
Member
- 92
- 0
- 6
- Location
- Spokane Valley, WA
Ha! No pictures!!! What a newbie mistake!!! ;-}
I just got back from a pre-recovery visit.
All the fluids look good, 4 batteries with a manu date of 06/12, right front tire a little low, a fair amount of body 'surface' rust, etc., but it started right up within about 20 seconds of flipping the switches.
Unfortunately, I ran into two issues:
1. I have no lights, including head, tail, brake, or turn signals. Though I have never driven the M939 series, I have been poring over the Operator's Manual since last week and become fairly familiar with all the ways I could screw up the Light Switch positioning. ;-}
Regardless, the brake lights did not alight when either the brakes were applied or the spring break was set. If this was a '77 Camaro, I'd swear I had a blown 15 amp fuse somewhere ... ;-}
[Side note, the gauges all worked just fine, though in the 7 minutes I had it running, I didn't detect much movement from the temperature gauge.]
2. The wipers were locked up solid. The air actuators were trying their best, but neither driver nor passenger side would budge. And since today was the last clear blue sky day we'll have until .... hmmm, I dunno ... maybe March?!??, I'd kinda sorta like to have those things working! 8-}
Unfortunately for me, this visit was a short one and I didn't even discover the problem with the electrical or the wipers until about 10 minutes before I had to leave.
It's rare when I can be accused of being cautious, but if I can find a local mechanic with a bit of appropriate experience, I'll probably just have it towed.
Anyway ... thanks for reading. I'll be starting up a separate recovery thread and copy this info into it for the sake of posterity. You know ... for the children!!!
I just got back from a pre-recovery visit.
All the fluids look good, 4 batteries with a manu date of 06/12, right front tire a little low, a fair amount of body 'surface' rust, etc., but it started right up within about 20 seconds of flipping the switches.
Unfortunately, I ran into two issues:
1. I have no lights, including head, tail, brake, or turn signals. Though I have never driven the M939 series, I have been poring over the Operator's Manual since last week and become fairly familiar with all the ways I could screw up the Light Switch positioning. ;-}
Regardless, the brake lights did not alight when either the brakes were applied or the spring break was set. If this was a '77 Camaro, I'd swear I had a blown 15 amp fuse somewhere ... ;-}
[Side note, the gauges all worked just fine, though in the 7 minutes I had it running, I didn't detect much movement from the temperature gauge.]
2. The wipers were locked up solid. The air actuators were trying their best, but neither driver nor passenger side would budge. And since today was the last clear blue sky day we'll have until .... hmmm, I dunno ... maybe March?!??, I'd kinda sorta like to have those things working! 8-}
Unfortunately for me, this visit was a short one and I didn't even discover the problem with the electrical or the wipers until about 10 minutes before I had to leave.
It's rare when I can be accused of being cautious, but if I can find a local mechanic with a bit of appropriate experience, I'll probably just have it towed.
Anyway ... thanks for reading. I'll be starting up a separate recovery thread and copy this info into it for the sake of posterity. You know ... for the children!!!
Last edited: