- 3,342
- 1,329
- 113
- Location
- The actual midwest, NM.
Shucks, I envisioned you pulling three water buffalos. But that's only 1,200 gallons.I've no need for more 3500 gallons. I can make two trips if need be.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Rear fuel tank m1008
- Thread starter corelokt
- Start date
corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
No buffaloes, but if I could find me one of the nifty canvas hanging things they put out in the field for canteen refills I'd hang it from a ladder rack and fill it with the high test washer fluid.
Of course that was back in the steel pot and OD Greens days.
I miss the taste of wet canvas.
Of course that was back in the steel pot and OD Greens days.
I miss the taste of wet canvas.
Last edited:
cucvrus
Well-known member
- 11,474
- 10,437
- 113
- Location
- Jonestown Pennsylvania
I probably have the M1009 rear cross members.
corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
My pm function is nada in Android. I am interested. How much for them?
- 3,342
- 1,329
- 113
- Location
- The actual midwest, NM.
I hope I never get hungry enough to find out what it tastes like.
corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
It used to flavor the water in the big hanging waterers. Especially after hanging out in the sun.
- 3,342
- 1,329
- 113
- Location
- The actual midwest, NM.
That's what I thought. Just yanking your chain, corelokt.
llong66
New member
- 453
- 2
- 0
- Location
- kokomo, In
Corelokt, if you want to do something similar to the way GM did it from the factory,, its pretty simple. I had an '85 Silvarado. There is a "valve" between the tanks and a switch on the dash. The fuel feed and sender wires from each tank go to the valve and you chose by simply flipping that switch, wherever you want to put it. even new the parts arnt to bad.
corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
I have one of those valves for my saddle tanks. I need to run heavier wires to it as I think the 22gga signal wire is way to thin. I thought it was powering a relay in it, but now I think it energizes a magnet directly.
I want a third tank for another fluid.
I'm waiting to hear about a set of the brackets for a blazer tank from a member.
I want a third tank for another fluid.
I'm waiting to hear about a set of the brackets for a blazer tank from a member.
cucvrus
Well-known member
- 11,474
- 10,437
- 113
- Location
- Jonestown Pennsylvania
Upon further inspection. I see that both the rear cross members are the same in the M1009. I have 2 removed and ready to ship. I done the hard part and cut them out of the frame. The ones on the box are the ones I want to ship you. $50. for the pair + shipping. I have them ready to go. PM me if you are interested.