Hi guys! I'm here again asking for help. Today I finally finished assembling the engine I rebuilt, but unfortunately it doesn't want to start. The diesel goes all the way to the injection pump but not into the injectors. On wire 54 there are about 23 volts. What can I do?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Rebuild engine dont start
- Thread starter Tato
- Start date
- 7,018
- 9,700
- 113
- Location
- Papalote, TX
Is wire 54 plugged into the correct terminal of the IP, would be the one closest to the front of the engine.
Was the IP rebuilt? if not was it running before the rebuild?
Do you have fuel coming out of the return fitting on the IP?
Can you hear the fuel solenoid "kick" when voltage is applied?
Was the IP rebuilt? if not was it running before the rebuild?
Do you have fuel coming out of the return fitting on the IP?
Can you hear the fuel solenoid "kick" when voltage is applied?
Yes,the wire 54 is closest the return hose, the IP is not rebuild and works well before the crack in the block.
Yes,fuel coming out from the return fitting.
Yes, the solenoid make click when turn the key
- 7,018
- 9,700
- 113
- Location
- Papalote, TX
Well then maybe some patience is needed
All that a working IP needs to pump fuel is power the the run solenoid, fuel to the IP and the IP shaft to turn, if you have all three of those things the IP must pump or it is not working correctly.
If you cannot get it to pump fuel you may want to remove the top cover (takes a special 5 point security Torx drive) and see if all the linkage is free and free of rust etc, you must make sure to install the cover correctly, youtube is a good source for directions.
Make sure you have 24V to the solenoid during cranking.
Others will have ideas also.
All that a working IP needs to pump fuel is power the the run solenoid, fuel to the IP and the IP shaft to turn, if you have all three of those things the IP must pump or it is not working correctly.
If you cannot get it to pump fuel you may want to remove the top cover (takes a special 5 point security Torx drive) and see if all the linkage is free and free of rust etc, you must make sure to install the cover correctly, youtube is a good source for directions.
Make sure you have 24V to the solenoid during cranking.
Others will have ideas also.
- 335
- 511
- 93
- Location
- Cleveland,TN
Like.......was the cam timed correctly............
papakb
Well-known member
- 2,285
- 1,188
- 113
- Location
- San Jose, Ca
Crack one of the fuel line fittings on an injector and see if it isn't just an issue with bleeding them. It can take a long time for fuel to reach them from in a dry line, certainly much longer than you want to run your starter.
- 4,414
- 4,207
- 113
- Location
- Brentwood, Calif
Just because you hear the click of the fuel solenoid doesn’t mean it’s moving the armature, open the pump up and make sure the armature moves effortlessly with your finger.
- 117
- 379
- 63
- Location
- Moyock, NC
Congratulations
May your efforts be rewarded with many trouble-free miles/years of service! Please continue providing pictures and narration of your complete Humvee build. Documentation of your experiences benefit many of us with similar challenges ahead of us!