cbvet
Active member
- 1,567
- 20
- 38
- Location
- Northwest (Knox) Indiana
Have to put a clutch in my 1952 Studebaker "Reo" gas deuce. I've put a few car & light truck clutches in, but never anything this big.
I seem to recall someone posting pictures of a homemade "Winch" setup used inside the cab to support the trans while moving it to the rear. Anyone know where that is?
Any tips on doing this job?
I still have to get the parts. Any one know a good source for the disc, pressure-plate, & throwout bearing?
Thanks,
Eric
I seem to recall someone posting pictures of a homemade "Winch" setup used inside the cab to support the trans while moving it to the rear. Anyone know where that is?
Any tips on doing this job?
I still have to get the parts. Any one know a good source for the disc, pressure-plate, & throwout bearing?
Thanks,
Eric