randyscycle
New member
- 467
- 3
- 0
- Location
- Rhoadesville VA (where!)
I have started working on my S250G and I'm getting it painted and ready to install into my M715.
I have the main plate on it that shows the dimensions and its in great shape, but all the others have been removed. There appears to have been 4 and possibly even 5 other plates. The rivets were drilled for the 4, and there were another set of holes that may or may not have had a plate on them.
Was there a variety of plates depending on what equipment was installed in the shelter?
Most of the usual MV suppliers only list the main data plate on their websites, that is the same one I have now. Does anyone know of a source for the plates other than the standard one? Does anyone have a good clear pic of their S250 plates?
Thanks in advance for any input!
I have the main plate on it that shows the dimensions and its in great shape, but all the others have been removed. There appears to have been 4 and possibly even 5 other plates. The rivets were drilled for the 4, and there were another set of holes that may or may not have had a plate on them.
Was there a variety of plates depending on what equipment was installed in the shelter?
Most of the usual MV suppliers only list the main data plate on their websites, that is the same one I have now. Does anyone know of a source for the plates other than the standard one? Does anyone have a good clear pic of their S250 plates?
Thanks in advance for any input!