Jeff H
New member
- 27
- 11
- 3
- Location
- South Jersey
I thought I was all done cleaning up and doing maintenance on my new to me MEP-803A. Then I saw a photo on this site of the second wiring compartment that sits behind the first wiring compartment. So I took off the top panel to investigate, only to discover a large mouse nest. Luckily no wires were chewed, just a lot of mess to clean up.
I want to screen the bottom and two side air intakes. To be effective against mice the holes need to be small. Large opening expanded mesh is probably not going to stop them. I was looking at perforated sheet similar to the guards on either side of the engine fan. But that restricts a good percentage of the open space.
Has anyone had any overheating or performance issues with screening the openings?
I want to screen the bottom and two side air intakes. To be effective against mice the holes need to be small. Large opening expanded mesh is probably not going to stop them. I was looking at perforated sheet similar to the guards on either side of the engine fan. But that restricts a good percentage of the open space.
Has anyone had any overheating or performance issues with screening the openings?