- 12,195
- 325
- 0
- Location
- gainesville, ga.
Dont reuse starter mount bolts
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Slave jumping
- Thread starter Rich Johnson
- Start date
SGT Estum
New member
- 274
- 0
- 0
- Location
- Twin Cities, MN
Just curious... what's the reason for this? Is it because the old ones are likely to have been over-torqued and therefore stretched out and likely to break? If that's the reason, shouldn't they be OK to reuse as long as they were torqued to spec?
- 12,195
- 325
- 0
- Location
- gainesville, ga.
dont have to over torque, once torqued, they are stretched, each time they are reused they are stretched more
- 2,520
- 18
- 38
- Location
- San Angelo, Tx USA Planet Earth
I keep a spare set for each CUCV IN the truck. Saves all sorts of problems.
And the CORRECT GM bolt is about $6.
And the CORRECT GM bolt is about $6.
DokWatson
New member
- 359
- 0
- 0
- Location
- Wasilla, Alaska
I had the same problem, two new batteries fixed it. Dead batteries can hold voltage, but have no amperage.
winerydale
Banned
- 13
- 0
- 0
- Location
- Dale Texas
Rick, I had a similar problem with my 1008. Check all of the conections and the ground. The problem that i found was inbetween the altinators, the conection. My 2 cents. David