- 333
- 262
- 63
- Location
- Denver, Colorado
Glad you got it solved, and Thanks for sharing!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
spicer 3053a top cover questions.
- Thread starter nathantc409
- Start date
- 6,987
- 2,526
- 113
- Location
- Montevideo/Uruguay
There you go...! That looks (and I'd say, works...) sooo much better, now.
nathantc409
Member
- 37
- 36
- 18
- Location
- Lumberton Texas
thanks, and i agree, almost looks stock. if it wasn't for the very long shifter travel between 1st and reverse it could have been just like stock. soon ill be in the market for another spicer 3053a. i want one to fully rebuild, swap out, and rebuild this one.. fill to the top with oil, and store it for a rainy day.
rustystud
Well-known member
- 9,284
- 2,995
- 113
- Location
- Woodinville, Washington
If you fill it to the top it will leak out the front shaft. There is no seal there. Fill it to the top of the fill plug only.
nathantc409
Member
- 37
- 36
- 18
- Location
- Lumberton Texas
I was just thinking filling one up for storage. I'm sure I could figure out a way to temporarily seal the front shaft. I just know if it's plumb full of oil for storage it can't get moisture in there to harm anything.
- 6,987
- 2,526
- 113
- Location
- Montevideo/Uruguay
Or.... you could always store it tilted up 45⁰, filled up to the top after unscrewing the breather...
Seriously: Don't do that, these things are not so delicate. Just smear plenty of grease on all moving parts of your "new" top cover; pour fresh gear oil all over the gear cluster while turning that output shaft over and shut the lid.
That's all it takes to keep it safe from any rusting - for decades.
