shannondeese
Member
- 651
- 18
- 18
- Location
- High Springs Fl
I need assistance if y’all could I’d appreciate it. The threads on my passenger side spindle are boogered. Do y’all know what size or where to get a die to chase the threads? Thanks.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Spindle threads
- Thread starter shannondeese
- Start date
- 9,604
- 1,494
- 113
- Location
- mid- michigan
This is the info for the spindle nut.
RH 16 threads per inch UNS
Nominal Thread Size 2.438 inches
RH 16 threads per inch UNS
Nominal Thread Size 2.438 inches
Attachments
Last edited:
texas30cal
Active member
- 484
- 87
- 28
- Location
- Brenham Tx.
You can’t get a thread file and small triangle files that will usually do the job
- 2,672
- 2,220
- 113
- Location
- Sunman Indiana
Used triangle files for years until I found this type 
will be the best$10-20 you ever spent for your situation.
will be the best$10-20 you ever spent for your situation.
- 6,995
- 2,565
- 113
- Location
- Montevideo/Uruguay
16 TPI / Ø 2-7/16" is correct.
And yes, a thread file might help, eventually... But no file or die will ever restore any flattened, missing, ripped-out thread sections!
SAFETY FIRST! Be very careful (and self-demanding) there when re-installing the spindle nuts. They must both screw-on smooth and tight, with NO play, whatsoever! Torque down to specs- to test, then loosen and re-evaluate.
If this was a front spindle I would rather replace the whole thing, for peace of mind..!
And yes, a thread file might help, eventually... But no file or die will ever restore any flattened, missing, ripped-out thread sections!
SAFETY FIRST! Be very careful (and self-demanding) there when re-installing the spindle nuts. They must both screw-on smooth and tight, with NO play, whatsoever! Torque down to specs- to test, then loosen and re-evaluate.
If this was a front spindle I would rather replace the whole thing, for peace of mind..!
texas30cal
Active member
- 484
- 87
- 28
- Location
- Brenham Tx.
Correction, that was supposed to read , you can get a thread file, I shouldn’t be typing after 12 hrs in the shop!!! That’s the thread file I was talking about, for really bad spots tiny triangle files work great , I used both all the time in a maintenance machine shop fixing other people’s boo boos.
- 3,224
- 398
- 83
- Location
- Tonopah, AZ
Use thread file or file should do the job.
- 8,546
- 2,787
- 113
- Location
- Monrovia, Ca.
There is a tool for that.....I'll get a picture
And it is available from Amazon....what ISN'T!
https://www.amazon.com/OTC-7402-Universal-Outside-Thread/dp/B0002SRGV6
And it is available from Amazon....what ISN'T!
https://www.amazon.com/OTC-7402-Universal-Outside-Thread/dp/B0002SRGV6
Attachments
Last edited:
- 3,265
- 3,393
- 113
- Location
- NORTH (Canada)
I have a smaller version of this tool (I just call it a thread chaser) and it works very well. I ran it through all the threads as a habit when I disassembled/reassembled my LDS.