diesel dave
Active member
- 129
- 38
- 28
- Location
- north central pa
1009 keeps breaking starter bolts. have tried shim-no shim,no luck.any suggestions???
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
starter problems
- Thread starter diesel dave
- Start date
Ken_86gt
Member
- 428
- 2
- 18
- Location
- Williamsburg VA
Does it have the bracket that attaches the back of the starter to the block?
diesel dave
Active member
- 129
- 38
- 28
- Location
- north central pa
yes
ralbelt
Active member
- 1,056
- 9
- 38
- Location
- West Warwick, R.I.
use OEM bolts, be sure threads in block are good, inspect gear on flex plate, one broken tooth will cause the starter to jump.
diesel dave
Active member
- 129
- 38
- 28
- Location
- north central pa
thanks guys,will try new bolts. and check the flywheel. not sure about the bolts we have used in the past.
91W350
Well-known member
- 4,414
- 57
- 48
- Location
- Salina, Kansas
On my first one, it kept skipping and had chewed off a few teeth on the flywheel. When I replaced the flywheel, I left the transmission and transfer case on my jack and installed some six inch long bolts to keep it lined up. After swapping the flywheel, it was easy to slide the gearboxes back oin place. Just a tip if you do have to change the flywheel. Glen