Hello. I am new here but I need help with a starting issue. We have a 1998 LMTV and the speedometer and volt gage went out while driving. Once we stopped the vehicle would power up with the switch but it would not turn over to start. We reset breaker CB77 (engine/gages). It fired right up. The next day the same thing happened. Speedo and volt gage went out and it wouldn’t start after turning it off. Does anyone have any suggestions? We are in northeast wisconsin if anyone can help locally. Thanks in advance!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Starting issues...need help
- Thread starter Mtbr3
- Start date
spankybear
Well-known member
- 884
- 911
- 93
- Location
- WA
Sounds like you have an intermittent short... Those are not easy to find. Get the TM and look at the wiring diagram. Does CB77 trip when you hit a bump? Best to use a multi meter and look for a short...
coachgeo
Well-known member
- 5,147
- 3,463
- 113
- Location
- North of Cincy OH
activation wire on alternator? common to go bad. Read thru https://www.steelsoldiers.com/showthread.php?155597-M1078-100amp-alternator-charging-issue for some insite on the excit wire. In particular post by suprman
- 10,458
- 6,532
- 113
- Location
- Camp Wood/LC, TX
Accelerator linkage saws on harness near gas pedal. Check there.
- 629
- 24
- 18
- Location
- Port orchard, WA
There are a bunch of wires that chafe on the gas pedal rod. Pull your dash and inspect.