Technical Manual Request

[nairb]

Looking for TM 9-2320-387-20 and have been unsuccessful finding it, does anyone have it?

 

[Action]

Remove

 

[Coug]

I don't think there is a -20.
I think they went straight to a -24-1 and -24-2 to go with the -24P parts manual.

The only 9-2320-387-20 I could find is an MWO, not a TM

 

[juanprado]

What model of truck?
This might be what you are looking for that I posted:

SMI 9-2320-387-14&P-1 l OPERATION, MAINTENANCE, AND REPAIR PARTS m1151 m1152

Supplemental operation, maintenance, and repair parts instructions for truck, utility: Expanded capacity, armament carrier, 4x4, m1151 (2320-01-518-7330) truck, utility: Expanded capacity, enhanced, 4x4, m1152 (2320-01-518-7332)

www.steelsoldiers.com

 

[nairb]

It's an m1123 I recently picked up from Leesburg

 

[Coug]

The M1123 you need the TM 9-2320-280-XX manuals to work on it, as it's an A2 truck. The -387 manuals are for the ECV/REV series of truck.

TMs for the M998-Series HMMWV

Listed below are a number of the TM's for the M998 series trucks. To save them to your computer, right click, select "save as". TM-9-2320-280-34.pdf TM-9-2320-280-34 Direct support and general support maintenance for the M998 series trucks. TM-9-2320-280-20-1.pdf TM-9-2320-280-20-1...

www.steelsoldiers.com

 

[nairb]

Mine has a rebuild date of 2009 and a red dot installed, maybe thats why it has the different TM for the serpentine belt?

 

[Coug]

not likely.
That's the generic sticker for all pre 196900 serial number serpentine belt systems whether they have Red Dot aircon or just a pulley blank in that spot. Well, other than the fact that it lists a TM that isn't used for any of the HMMWVs as far as I can tell.
The Red Dot aircon doesn't change anything about the belt routing, only that the belt is about 10 inches longer and routed the exact same. (Or so I think. There might have been slightly different routing for one of the idler pulleys on top that it went over both of them, rather than over one then under the other, but at this point just run it like the sticker shows and call it good)

Just ignore the TM listed on the sticker and use the standard manuals.

 

[nairb]

Thanks! That’s good info about the ac, I was looking for this because I’m planning on removing all the ac components. If anyone needs red dot components in Texas let me know.

 

[Guyfang]

As far as I know, the TM does not exist. I have sent a question to someone who should know.

 

[Guyfang]

Look in TM 9-2320-378-24-1

3-81. Serpentine Drivebelt Maintenance (Serial Numbers 196900 and Below) 3-142
3-81.1. Serpentine Drivebelt Maintenance (Serial Numbers 196901 and Above) 3-142.4

Please let us know if this helps.

 

[Action]

Look in TM 9-2320-378-24-1

3-81. Serpentine Drivebelt Maintenance (Serial Numbers 196900 and Below) 3-142
3-81.1. Serpentine Drivebelt Maintenance (Serial Numbers 196901 and Above) 3-142.4

Please let us know if this helps.

387, not 378

 

[Guyfang]

Correct. my mistake.

 

[Guyfang]

The M1123 you need the TM 9-2320-280-XX manuals to work on it, as it's an A2 truck. The -387 manuals are for the ECV/REV series of truck.

TMs for the M998-Series HMMWV

Listed below are a number of the TM's for the M998 series trucks. To save them to your computer, right click, select "save as". TM-9-2320-280-34.pdf TM-9-2320-280-34 Direct support and general support maintenance for the M998 series trucks. TM-9-2320-280-20-1.pdf TM-9-2320-280-20-1...

www.steelsoldiers.com

Coug is correct. Its the TM 9-2320-280-24-1. I just went back to look again. I had too many TM's open at one time. When looking for what truck is in what TM, its always best to have the Model number, AND the NSN. Then simply look for that on the front cover. My mistake.