transfer case

[wharfman]

can any one tell me what i need to run a shaft out of the back of transfer case on a m52 to run a pump and were to get it i have the pump just need to hook it to transfer case
thanks Dave

 

[hemichallenger]

You need a rear pto for the transfer case.

 

[73m819]

a xcase pto from a 819,246, 815, maybe 820 with a lift gate, why not use a dump trans pto with the rear faceing drive, this drives the pump for the dump

 

[wharfman]

it has a winch off the trans need to go off transfer

 

[Wildchild467]

I have wondered this too. The trandmission PTO's that are made to have the rear output, must be able to be controled to have only the rear turn if they want to, correct? if the front turned also, it would fry the band brake for the winch clutch. so does that mean the transmission rear PTO output are only one speed (unlike the winch)? It seems like they would have to be.

 

[wharfman]

does any one have a shaft for back of t-case or now were i can get one

 

[Floridianson]

I have wondered this too. The trandmission PTO's that are made to have the rear output, must be able to be controled to have only the rear turn if they want to, correct? if the front turned also, it would fry the band brake for the winch clutch. so does that mean the transmission rear PTO output are only one speed (unlike the winch)? It seems like they would have to be.

Correct and correct one speed.

Wharfman I might think about getting a double trans pto might be easer to find.

 

[wharfman]

do you know were i can get one

 

[KsM715]

M817 w/w. Best bet is to put a WTB add in the classifieds and all the surplus suppliers that have one for sale will contact you.

 

[stumpjumper83]

I think you want the pto off a dump, they are double sided and as mentioned are independantly controlled. I didn't know that there was an option for driving something off the t-case.

 

[Floridianson]

I think you want the pto off a dump, they are double sided and as mentioned are independantly controlled. I didn't know that there was an option for driving something off the t-case.

Yep

 

[jaxsof]

And that 5-ton PTO can have the shaft reversed and stuck on the right side of a 6453 also. The Manual shows a part, and PN for the TC PTO

 

[Floridianson]

And that 5-ton PTO can have the shaft reversed and stuck on the right side of a 6453 also. The Manual shows a part, and PN for the TC PTO

I think he want to keep his winch.

 

[wbv]

I think you will want the transfer case PTO from an 815 or 819. This one can be engaged with a lever from the cab. The transfer case PTO on the 816 runs at all times and cannot be disengaged (according to the info have). Look in TM 9-2320-260-34-2 on pages 16-251 through 16-254.

I bought one from Boyce and installed it on my 818. Pictures attached.

Installation was very simple.

wbv

 

[wharfman]

Thanks that looks like what i need do you know what they sell for

 

[wbv]

Boyce sold me the PTO, linkage and in-cab lever for $850.

The included link rod was too short so I had to make my own using 2 fine thread bolts and metal rod.

wbv

 

[topo]

I used this some pto for a winch and used a air cylinder to shift it in or out .