street legal humvees
New member
- 12
- 0
- 1
- Location
- punta gorda ,fl
we are hoping to get some guidance on an issue about to drive us nuts we are finishing an m1123 overhaul and after fuel issue nightmares, we thought we were home free but the the trans will operate only in reverse and in first , and of course no dice on testing codes as we don't have a J1 6 pin connector (we found a really cool post detailing how to make one using an old gm port , but just ordered the parts so not here) / [FONT=arial, sans-serif]We [/FONT]had a couple tcm in shop so changed out and no difference in fact we ran truck w tcm disconnected and it runs the same ! is this limp mode ? any ideas as to whether a [FONT=arial, sans-serif]bad solenoid or speed sensor could be the issue / also my understanding of these tcm is that they are plug and play since the problem exists no change w 2 diff tcm and even w tcm NOT connected could it be wire harness any suggestions ? we are at wits end !!![/FONT]