crazymechanic
New member
- 24
- 0
- 0
- Location
- MD
Thanks keith
that helps Big time , I never messed with the upper wires on the block im so pissed this was always screwed up I only disconected the stator wires assuning everything else was good my wires are all wrong ,IM curious wether the mag is now bad as well possible demag from current , because I should have one good used stator still sense I got a used set, but I put it in and it still had low a/c voltage 20 something a/c , has 7 ohm across and no shorts from any directions , I guess stators are hard to diagnose with out proper tools , Im just going to put another new stator and reg on it , is there any way of testing the reg with a multimeter when its disconected to see if this is still Ok ?
thanks again !
that helps Big time , I never messed with the upper wires on the block im so pissed this was always screwed up I only disconected the stator wires assuning everything else was good my wires are all wrong ,IM curious wether the mag is now bad as well possible demag from current , because I should have one good used stator still sense I got a used set, but I put it in and it still had low a/c voltage 20 something a/c , has 7 ohm across and no shorts from any directions , I guess stators are hard to diagnose with out proper tools , Im just going to put another new stator and reg on it , is there any way of testing the reg with a multimeter when its disconected to see if this is still Ok ?
thanks again !
Last edited: