deuce2
New member
- 60
- 0
- 0
- Location
- carson, nv
Thats a great idea!
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Insurance is a good thing !What did I do to my deuce this week? Put insurance on it so's I can drive it home from pick up on Saturday.
The deuce won't go over 20mph? Something major is wrong.. is it in low gear? How is it running in neutral?I think I may just drive it for a little while. She's running better and better every time. Still can't get her above 20mph yet. slow progress is better than no progress.
If it's been sitting, could be rings, or just a little gummed up, my deuce gasser the first few times I had her going down the road-would not want to climb any sort of incline, fell on its face. A couple more runs and now she only slows down on the steepest/longest inclines.The deuce won't go over 20mph? Something major is wrong.. is it in low gear? How is it running in neutral?
Sent from my SM-G935T using Tapatalk
Nice to hear it worked itself out. I hope it does the same for this truckIf it's been sitting, could be rings, or just a little gummed up, my deuce gasser the first few times I had her going down the road-would not want to climb any sort of incline, fell on its face. A couple more runs and now she only slows down on the steepest/longest inclines.
Sent from my iPhone using Tapatalk
It had a gummed up IP. I replaced it, and changed the oil in the motor and the trans. She runs just fine in neutral. I put some marvel mystery oil in it and that helped alot.The deuce won't go over 20mph? Something major is wrong.. is it in low gear? How is it running in neutral?
Sent from my SM-G935T using Tapatalk
I also literally have only driven her once.I just went and started it, and found a major hemorrhage of motor oil coming from the oil canisters. Guess my new seals must have shifted or went bad.. crummie.
Check installation torque, its like 75 or 80 ft lbs. Most don't put enough on them.I just went and started it, and found a major hemorrhage of motor oil coming from the oil canisters. Guess my new seals must have shifted or went bad.. crummie.
Yea that may be it.Check installation torque, its like 75 or 80 ft lbs. Most don't put enough on them.