- 84
- 20
- 18
- Location
- Albuquerque, New Mexico
Who has the gears? What's available? Waste of time
or???
or???
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
what is a good gear ratio for swaps on the diff in a M1008 CUCV PU?
- Thread starter DaninNM
- Start date
Add an overdrive unit, as I believe, when all is said and done, the cost is the same. If I was doing gears on the stock 08, I'd probably look at a around a 3.50/3.70's set, just to get the rpms's down, but keep it easier for acceleration. Just my 2 cents.
Keith_J
Well-known member
- 3,657
- 1,323
- 113
- Location
- Schertz TX
Lots of work to swap two ring and pinions as new carriers are required.
A 25% overdrive is equivalent to 3.42 axle ratio, a good improvement as it puts engine speed at 2400 RPM at 70 MPH.
A 25% overdrive is equivalent to 3.42 axle ratio, a good improvement as it puts engine speed at 2400 RPM at 70 MPH.