Winch drive shaft dimensions

[shannondeese]

I am in a pickle. My winch is from a gasser deuce. My shaft is at high angle driveline to get remade. I need the total length. And the shaft diameter. I know it's smaller for the multi fuel than the gasser. Thanks.

 

[shannondeese]

Just wanted to say thanks to Gimpyrob. He got me all the dimensions I needed.

 

[mbehne]

Might not be a bad idea to post up the dimensions, that way if some one searches for them again, they may find the answer easily.

mike

 

[jatonka]

Wish I saw this sooner, Kenny Kublo at Kublos Surplus in Brackney Pennsylvannia has them brand new for around $120 each for the M35A2. JT out

 

[shannondeese]

Multi Fuel Winch Shaft Dimensions. Total Length 54 1/2 inches. Shaft Diameter 2 inches. At 46 1/2 inches the shaft necks down to 1 inch for clearance. The spline is a 15 spline with a double tooth to act as a key way. All measurements are taken from the center of the U-joint cap to the end of the splines. Hope this helps. Jesse at High Angle Driveline is building me one for really good deal. Thanks to Gimpyrob for the help in getting me the measurements.

 

[cbrTodd]

Wish I saw this sooner, Kenny Kublo at Kublos Surplus in Brackney Pennsylvannia has them brand new for around $120 each for the M35A2. JT out

Just FYI, I sent an email to Kublos earlier this morning and he told me he was sold out. Thanks for looking though, John.