pryorfire48
New member
- 16
- 0
- 0
- Location
- pryor, oklahoma
I have a 53 M37 that blew a head gasket. I took it off and had it milled and replaced it with a new gasket. i also took this opportunity to clean and repaint everything on the drivers side. It's all back together and i can't get her to fire off.
1. checked voltage to distributor and have 25 volts
2. checked the gap and put it to .020
3. replaced the cap. the old one was pretty worn
4. checked voltage on both sides of coil and have 25 volts
to be done.
1. next is to double check top dead center and timing
2. need to check for spark at plug end.
Any other ideas?
1. checked voltage to distributor and have 25 volts
2. checked the gap and put it to .020
3. replaced the cap. the old one was pretty worn
4. checked voltage on both sides of coil and have 25 volts
to be done.
1. next is to double check top dead center and timing
2. need to check for spark at plug end.
Any other ideas?