Search results

Buddy, Run! The mep 1041 unit runs at 400hz. Unless you will use it just for power drills or an airplane it wont work. You need the mep 1040.

Thanks for the suggestion. About a year back i ordered one but it did not fit even after removing the whole filter assembly with neck. It was not wide enough to fit in the down pipe. I even oiled it up a bit but no dice.

Howdy folks. Im looking for a fuel filler elbow for the mep 007b. I have included a foto of the item. Thanks

When they went for cheap, no one had the 1040. Its a different story now. Stay on the gp site, you might get lucky.

Send me the sellers contact. I will give him 600$. 😅

My 1040 has gone up to 15kw and does not shut down. Just gives me a overload error. Loving it.

Place s2 (start switch) in the run (middle position) amd flip the red battle short switch. That will turn on the pump. Let it run till the sound changes. System should be primed. If you dont hear the pumps check for 24v and pump power inlet. Also, unscrew the bottom pump lid and make sure the...

I have a control cube i can sell but its pricey. I love my 1040 but these fancy electronics are always and achilles heel. Check the ground strap first. You can take these boxes apart quite easily.

I have a battery tender 24v maintainer and a batteries plus branded 24v charger and maint. I lije the batteries plus better and it was 120 bucks.

Ok, im going to have to correct your friend here. I have 5 of these units in the lot right now and the newest, an early 90's unit would not start. I suspected the magpickup. Took it off, cleaned the tip and reinstalled it to 9.5vac. Started right up. How did i get to 9.5vac, well i took the...

I always wear gloves when dealing with gensets. Cheap lifesaver.

Howdy folks. Need a ride for my Hmmwv from albany to jacksomville. Anyone make that route?

Where did you get the kit?

Found them under a Bosch part# ADN6S526. Thanks for the help.

Howdy. I need new injector tips for a 003a im rebuilding and cant find the rebuild kits or the tips. Anyone have any to sell? Im also looking for the injection pump rebuild kit but ambac is out. Thanks

I actually just received my 813a today. Bought it to to replace a seized 803a. Spare parts is what these 400hz units are good for. You can use the genhead as a good boat anchor. Let the fun begin.

Howdy. Ive got 2 mep 007b 100kw units that need a lift from Klingerstown Pa to Jacksonville Fl. I will even throw in a free trailer if you want it.

Rubber hose with a pex brass plug then a clamp and presto.

On a side note, make sure you retorque the oil pan. These white engines love to leak oil. Also, check the oil drain valve, I end up changing them cause they leak. The best part about this series is that they can be reconfigured to single phase.

This is the first thing you need to realign. Tb1 or voltage reconnection board.