Search results

The 2 plates I used....not in kit...they are 12342665 at macmotors for 28 ea.

I have: # 1,2,3,7,8,9,14,16,17, and some other small hardware.

There might be 2 on a Late Hmmwv....one on trans wires...I think other at horn wires. I have used takeoffs.

One install i did...I used thick large washers for # 5...Somewhere I have a kit without the big part. There is a special trailer plug bracket also.

I don't know....you sure there ain't no Chinezz stuff on that ?....

Cast part # 22 is not used on the extension thats shown...so no way to grease it...so pre-grease it. There are 2 versions of the extension...most out there don't use # 22, but the older version does....but not easy to find.

That is a noise suppression capacitor # 12469147....here's one still mounted on trans sensor bracket...I have spares.

That antenna base looks like a AS-3900 which is a Sincgars antenna....If it has one connector on the bottom..... Sincgars, will operates on the same freq. as RT-524's. The RT-524 antenna base is a MX-6707 which has 2 connectors and a tunning knob.....this one will work with a CB.

All the boxes have the big silver relay ..Even the Nartron smart start....except only one late box the KDS smart start uses some little black relays.

I found a paper copy of instructions.

I have lots a NOS retrofit harnesses with a light.

Probably a test bench motor than they ran until it quit.

Later brace replaces the weak one..I have a few.

If you put a 242 in...there's 2 types...early and late...they have different size slip yokes.. And you will need to change 2 of the 3 drive shafts and maybe rear diff yoke.

You should have a 200 amp Alt......so the tach that normally goes in the W/SHD. tach bracket is the round connector non-lighted tach. Harness for it is a 6011545...it hooks up to alt regulator. You can use the Bussbar tach and wire it to 24vdc, and tach drive on back of motor and it is a lighted...

Normally if its a Marine Corps truck...no off road stamp....Auction should say [ The Humvee sells with a clean SF97. ]

I have a few sets of these plates made up to allow a Luverne guard to be installed on winch plate using Non-winch mounts. No drilling needed.....uses existing bolt holes. Winch plate has to have frame extensions.j

Some field mod...see where it connects on other side..

Thats me...

I have the frame extensions needed for the proper Luverne install..... You already have the plate. 2nd pic is Luverne winch and non-winch mounts. I had a shop make spacers so a NON-winch mount will work on a winch plate with no mods needed.