Search results

Start a new thread as to not hijack.

803? You mean 804, right?

Did the viewing window clean up or does it still look dirty?

That thread zed posted above, tm 9-6115-644-10, adobe reader page 54, or tm pg 0005-4

Fuel psi?

You said the hz gauge only goes to 11 o’clock, are you sure the hz selector behind the gauge cluster is selected to 60 hz?

I wouldnt,, i would use conv plug, or load lugs. I prefer conv plug, it has juice all the time

I use an external voltage hz gauge as a backup that i plug in to convenience plug. Its not precise, but works to verify AC Multimeter 6in1 Combo Meter Voltage 110V 220V Current 100A Power Factor KWH Frequency Multifuction Tester...

Take a video, and post

Bontonjeff, did you get the answers that you were looking for?

Decrease fuel pressure, after first test fire. better to have not enough than too much and flood the chamber sounds like it wasnt clean burning if the sight window was dirty

I think you are running wayyyyy too much fuel psi, try 90 psi or less. I am only running 70? Psi , ithink. Also i think max waste oil would be like 20% or less. I think I remember reading about waste oul use but don’t remember the number

Hanging the k8, was more of a cooling effect rather than a grounding issue. I drilled holes in one k 8 that was being problematic to manually operate the switch inside, but there was no need to manually operate it, it went to work and is working to this day in a body shop

Ok so single ph is 2 legs of 120v, 240v measured leg to leg. 3 ph is 3 legs of 120v, 208v measured leg to leg you can use a 3 ph generator to get single ph by using only 2 legs. But you will only have 208 v 804 805 806 are 10 wire generators therefore they cannot be reconfigured to a true...

10kw constant with 10% surge if you use 2 legs of a 3ph generator. 2/3 of rated capacity. the tm states you can use as single ph, use terminal 1 and 3.

The voltage reconnection board is only used for selecting required voltage...120/208 or 240/416

You can get 2 legs of 120v, but across both legs is only 208, not 240v. Generator will produce about 5 kw per leg, so single phasing a 3ph genny will only get 2/3 rated power

Jeff, you do understand that an 804 is a 10 wire not 12, correct?

Yanmar turbo motor is only thing i know of, someone else will pipe up and correct me

804 is a 10 wire head, not 12. I load tested my 804a at 18k with no issues, it didn't like 21k. The video is after a used motor swap, so it was smoking more than normal to blow out the cobwebs https://youtu.be/HZuCSmFHLV4