Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I would say if you're off-road >50% of the time it is worth keeping. The biggest problem that I see with it is the long increase from cross-country to highway modes and the stress that places on the truck's air system.
See my third post. Inflate all of the tires to the same pressure (30psi is enough) and try to run the CTIS unit without pressing any buttons. If they deflate, most likely a hub seal is to blame. If you get five lights, you have a large leak upstream of the wheel valves that needs to be fixed...
Seeing as the OP is using a 936, running empty is not the problem IMO.
Slipping and hard down-shifts may actually be caused by the modulator cable sticking (hard down-shift) and being out of adjustment (slipping up-shifts). You can in fact have both at the same time, I know that I did. I...
Partially closing the valve would not only slow the application, but it would slow the release as well. I think I recall reading on here that the biggest problem is the difference in behavior between S-cam brakes (on the trailer) and wedge brakes (on the truck). Not sure if there's a way...
You might see if Ouverson would be willing to buy some. I know they're not in the 5T axle business now, but I'd be surprised if they weren't interested at all...
About that, has anyone opened up the CTIS controller to see if it can be adjusted? It may be all in the firmware, but its also possible that there's a group of pots in there to allow adjustment for any situation.
Definitely some logic on that circuit board. The 14-pin ICs are quad NAND-gate packages. I can't tell what the TO-220 packages are. There must be some kind of voltage regulation on there since the CD4011s are only rated to 20Vdc. No timing hardware that I can see unless it uses an RC circuit...
To answer Powerstroke's question, yes I have used off-the-shelf QR valves in place of the military ones and they work just fine. That being said, Suprman nailed this. On my truck, one of the hub seals had worked its way toward the center of the hub since the truck was driven without the CTIS...
While it doesn't look the same, you can get QR valves at NAPA. Need to know the in and out thread sizes (in is in the center, out on the sides). I can get part numbers tomorrow afternoon, as I have some lying around.
4WD van != AWD van. The Quigley conversions use 3/4 ton pickup running gear, and in the case of the Ford vans they're essentially a 3/4 ton truck underneath anyway. As for your Astro's crumple-zone problem: that was an issue with both the Astro and Safari, where the crumple zone was...
You might look into a 4WD van, or convert used van-based RV to 4WD.
Regardless of what you do, definitely get front and rear winches. In addition, make ground stakes to make self-recovery in areas without anchor points possible.
M939s don't have much in the way of electronics to break, so there's that. I've never been in or driven an LMTV, but I know others here have and can speak to the benefits of one over the other. Personally, I like my 8.3-powered 5T.
This is a little off-topic, but DOT numbers on sub-CDL weight trucks is a requirement if used for commercial purposes. This is becoming a big sticking point with DMV & DOT as increasing numbers of people use 1-ton trucks for hot-shot type hauling.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!