Search results

I'm not implying anything too logical here but, I don't have a ground wire on my box and it works fine.. I doubt disconnecting it would do any damage.. Just saying....

So...what’s the numbers you found ????

ummm... Tow Missile configuration humvee.......I don't think that's a unit number.. That a model number for your truck. Look for lettering inside door frame, drivers side. Also other insightful numerical things may be found under spray painted over areas ( sand/remove paint slowly to...

does yours fluctuate 9-12 lbs like a pulse with engine running, then settle to around 9 with off, then bleed down ? I think my gauge is finicky

IN........ Many thanks SECO

Ummm.. 1987,,, That would be a 33 year old rig, not 23 🤣

I would probably get this issue out of the MODS and Improvement thread and start a new thread with your title of choice.. "I left my key on all night, and now my HMMWV wont start.....HELP" That might work 😁

Was changing out the shoes on the wives H2... so I rolled a wheel over and tossed it on the 998.. Not quite big enough

Its the PCB...Protective Control Box.... Do a search, learn all kinds of good stuff about them Right Here on Steel Soldiers 😁

Purdy

In hindsight, I might have tried a long ratchet extension.. But the punch was the right length and fit right on that small edge.. Few dings, mehhh

Got the fan clutch unstuck 👊🏼 Thanks for all the info.... Ocho

I have an idea.. New solution.. Two birds, one stone type of thing. :cool:

Crawled out from under my dirty bastard 88’ M998 I was cleaning/prepping for paint to finish up renewing these beauties.. Ocho

Well, to add to my plight.. I also have another radius tube I ordered months ago, and it is even shorter than the 10.87” model..it’s like 8 1/2”... My front radius rods are close to the 10” rods, but my rears are definately 12”.. guess I’ll do some calling around .. feel free anyone to look...

Yes like that one, if that one is 12" and not the 10.87" that I've been finding everywhere. Im just concerned with the shorter length because my rod ends will most likely only screw into the radius rod up to the far end of the relief cut and not completely into the tube.. Not sure if it...

Tearing down rear end on the 88’ M998. Want to replace the rear radius rods because one is bent and one has some bad threads... So I can’t seem to find anything longer than 10.87” as a replacement.. The ones on my rig are a solid 12” long.. Has anyone else had a problem with this or know...

Transmission modulator.. has o ring that might be leaking where it goes into transmission.. Can remove bracket holding it in and slide out to check/replace O ring.. looks like housing may be leaking though because of the bit of RTV smeared over it.. easy enough to get a new one and replace...

put in an air ride seat :ROFLMAO:

Tore down, rebuilt... now I can finish putting rear end together..