Search results

the cucvs were all automatics. mine has a high idle when its cold

what controls the wait to start light on my m1008? my light doesnt stay on as long as it should. i have found out the truck starts better if i wait about 5-10 seconts after the light goes out. i would like to fix the light to stay on longer

i would leave it 24 volt. its alot easier to work on. new 24 volt starters are not that much more expensive.

the batteries need to be good and hot because you may have to crank for a while.

i have a dodge w350 with a dana 60 front like the m1008, and my truck did that when i first got it and everything in the frontend was good, nobody could figure it out, come to find out it was my wheel bearings, i replaced all my wheel bearings, races, and seals, cost me $125 for timken bearings...

rapco parts "383 green" is what i used and it matches very well considering the original paint is almost 25 years old

i would try the fuel pump first, its cheaper and if you have to put a new IP on it you would want one anyway.

whens the last time the fuel filter was changed?

oh i sent in my euc before i bid will that mess everything up?

i am wanting to bid on some m1009s on gl and from what i have read on here you need to fill out the euc before you bid? and the first place to fill out is asking for the event number what if you want to bid on multiple items? someone please help me get started. thanks, bryan

connect the negative cable somewhere on the motor.

out of the black plug that you take out unscrew the plug crank motor (fuel will come out of the hole) until you see no more air bubbles just straight fuel. put the plug back in and conect pink wire and start engine

disconnect the pink wire on the injector pump (that keeps the engine from starting) and there is a black plug on top of the fuel filter housing unscrew it with a large flat screwdriver and have somone else crank engine until pure fuel (no air bubbles) replace plug, connect pink wire, and fire it up.

i have never had any luck and i have tried many times. its best to just replace the speedometer.

go to your dealer and tell them you want one for a 94 6.5 diesel

i was told a dodge wheel will fit on a chevy but a chevy wont fit a dodge something about the center hole

if the gauge goes way past full check grounds and connections first.

I need a brake master cylinder for my 1985 m1008. Is it the same as a civilian k30 with a 6.2 or is it a military specific part? i remember reading on the old site in the pm articles that there is a difference in the m1008 and m1009.

if you cant find one, i will swap you an od for a regular 3 speed one

this fixed my problem but is there any specific wattage to use? i used 2 10watt 150ohm resistors they had several different wattages availiable.