Search results

Joel, I finally found the special shouldered bolts from Sam Winer in Ohio 330-628-0948 (Robert Zetzer) I think he charged me about 25 bucks for a set (6 long / 6 short) I have a drawing with dimensions if you need it....pm me Don

Joel, I went through the same steps recently and all went fairly smooth until I tried to set the winch between the frame rails. The rails were 1/4" to narrow for the winch to fit. I had to loosen all 40 of those bolts and unbolt the bumper to try and squeeze the winch in. Then when the winch...

Completed the teardown last night. The only thing obvious was the absence of the "o" ring between the air cannister and the valve body, although the gasket was there. All the other seals/ cups appear to be in good shape and in the proper sequence. The bores of the valve body also appear quite...

I finally gathered the courage to work on my malfunctioning airpack. Upon opening the air cannister side I discovered a lot of brake fluid. The airpack looks to have been replaced somewhat recently along with the master cylinder. I have had the truck for three years so it would predate that at...

ken, wrong place, westech has the correct adjusting point. What you are talking about is the servo pressure valve sleeve....check TM9-2910-226-34 section(3-109)

hey all, just read through this topic.....I have been opening up my fueling rate cautiously over the winter....night and day difference! Anyway after you pull off the triangle shaped cover you see the threaded metering rod with the two nuts. It is my understanding that the metering rod has a...

mcinfantry, that is one of the guages I have been looking at cause the styling fits the old deuce better than most. I will be very interested in how the install goes....keep me posted for sure. and hot rod I am still thinking about the snowmobile pyro cause you can pick them up pretty cheap and...

Bjorn, Where did you tap into for your boost gauge? I found a pyro with two needles so maybe i will do a before and after turbo setup just for fun...

I am looking to install a pyrometer on the deuce. Who has been down this path already? Thinking about one from the aviation industry as the autometers of the world look wrong with the other guages. Some need power, most 12 volt, so pull power from 1st battery I guess. Where on/in the exhaust...

Lance, the info I was given on the adjusting of the sprag case amounted to a couple of photo-copies. They came out of TM9-2320-209-20 pgs 267 & 268? Maybe some help there...

[No message]

[No message]

[No message]

new guy screwed up first signature Need to know what size bolts are used to connect winch body to frame extention brackets (total of 12). I cannot find "originals" anywhere.