Search results

I was going to use my genset today and went from 3ph to 240 single with the selector switch. It didn't seem right so I thought I would turn it back and it was locked up solid. I thought I read about a similiar condition once but can't seem to locate the thread. Any Ideas? What to look for? Thanks

All of the gen sets I have gotten from GL have been missing the oil filter spring and retainer. Not wanting to dump alot of money in them before knowing if they worked, I found a spring at the local hardware store and an SAE flat washer that seemed to work just fine. I maybe wrong but the...

I fired up my 002A today and hooked it up to a military A/C unit. Its a 208 3phase Zeks 36,000 BTU base mounted unit. I think this is comparable to a 3 ton unit. The 002 got it running for a minute then tripped the main breaker, gave it a few minutes rest and hit it again this time it ran for...

Home depot has a small hand held volt/hertz digital meter for $39.00 thats what I use. My frequency meter on my 02 bounces around a bit, so I depend on the hand held unit.

Saw some 002's go as high as $1300.00 in Chambersburg plus tax and fees $1515.80 now go get it sounds a bit much to me

22NF batteries fit just fine. Auto Zone $76.00 each

The ball stud on mine broke also. Mine broke at the rod end because it was plastic. Went to the local speed shop and got a new ball stud made of metal and works great.

Ok found the problem inside the fault light box. Took it apart and there was a white wire going to each of the lamp holders, jumped from one holder to the next. The 2 lamps that worked were over volt and over freq, the jumper wire from over freq to the next lamp was some how shorted and that...

No battle switch is off. I took each bulb and checked they are all good.

I had my 004A running my fathers house during Irene and thought the same thing about fuel consumption ran about 10 hours and still above 3/4. From my best guess the genset ran about 26 hours on a full tank of fuel before it ran out of fuel and shut down. This is the first time we ever ran for an...

Thanks Peter, I did think of that and I will get into it tomorrow. The reason I didn't check bulbs first is because the oil pressure light does come but goes off in the test position.

I have a MEP 004A. We used it during Irene to power my dads house and garage. When I got it back to my shop to go over it I noticed that when I push the toggle switch to test the fault lights only 2 lights come on now. over volt and over amp I think thats it. They all used to come on when the...

Just acquired a 36,000 BTU Zeks base mounted air conditioner. It is 3 phase which I have in my shop and was thinking of using it there. Anybody familiar with this unit? Anyone have a manual for this unit? It almost looks brand new, but needs a power cord and 14 lbs of R22 to get it going. Any...

After the unit is running, try and hit the start button again for just a second and see if that works.

Has anyone tried using bio diesel in the military diesel gen sets? I have a mep-004 and was thinking of giving it a try. My car,truck and oil burner seem to run fine on it.