Search results

Help me identify which turbo this is. I don't see any markings on it.

No it's not a whistler. Believe the guy I bought it from said it was a D turbo

How can I specify which turbo I have to order a rebuild kit for

No no flame heater

I'll do it tomorrow and take a gander at it.

I let it idle b4 I take it out usually to let it warm up a bit.

Could it be from unburnt used motor oil?? There is a good bit of that in the fuel tank.

There's the oil leak.

Yea there is a slobber tube

Right now there is a high percentage of used motor oil in the fuel. Am I lucky enough that it possibly could be unburnt fuel leaking out??

Where can I get a rebuild kit for it??

That's what I figured. Easy to replace?? Hurt to drive until I get it fixed??

For the past while I have noticed oil all over the starter and from end of my deuce. To some time and pressured all the oil off and fired it up to see where the oil was coming from. After it ran for a while I got looking and there is oil coming from the exhaust side of the turbo where the...

Correct me if I'm wrong but to eliminate end play of and that what the shims are for the are behind the bearing cover correct?

Getting ready to put the output shaft bearing back in my transfer case and I'm trying to find out how much end play (in and out) the output shaft should have.

Can't believe it would need new bearings considering the tag on it says it was rebuilt in the fall of 1991. But I'll dig in to it later.

Thanks. Can this be done with the transfer still in the deuce or not??

Was driving the deuce last night the parking brake got stuck on. Had to drive bout 2 miles in slow traffic till I found a place to pull off and mess with it. After I got it free it was fine at low speeds, but on my drive home I have a vibration coming from some where. I crawled under it today to...

Got the key ways out and everything done with the winch tonite. Goin to put it back on the truck tomorrow. I had to beat the bejesus out of them to get them out. Thanks for the input!

Thank ya much. I tried that last nite but ill keep trying. Just a little scared of screwing those key ways up.