Search results

Set ran great for several years. I purchased in WA from GP. Only major work was replacing well nuts, filters and charging the batteries. Fast forward I had a fuel issue a few years ago during the winter that cleared up after replacing the water separator. This summer had a few hard starts...

Saw your video on the IP rail. Very helpful [emoji106] I doubt the rail/governor is at fault as the assembly moves freely at the throttle and solenoid arms. Thinking my next step is to remove and clean/inspect IP’s. Good opportunity to replace a seeping low pressure hose assembly. DC is...

Lovely job Siri... ;) Fuel stop solenoid is pulsing off of stop when cranking, not holding steady. Verified fuel pump is operational and delivering plenty of pressure to injector pump low side feed. Validated fuel pressure/feed at the filter output line. I was not able to get any high pressure...

Fuel filter and oil PMCS completed. Waiting on water separator part. Generator is acting like it has no gel fuel delivery. Fuel shut off solenoid is pulsing position off of stop on cranking. Tried running the fuel rail by hand during cranking-no difference. Next up is checking low pressure...

Disregard, MIP is functional and starter is no longer dropping out. Why? Not sure. All I did was look at FU1, and circuit breakers for MIP and DC. Going through PMCS now. Replacing fuel filters and oil service. Air filter is fresh/clean.

Charged both batteries. One was low. Malfunction Indicator Panel is inop. Sent from my iPhone using Tapatalk

Finished rebuilding the RF supplemental door. New inner plate, rivets. Paint and new weatherstripping comes later. Sent from my iPhone using Tapatalk

Decibel X… Worked great on evaluating effectiveness of insulation in my prior HMMWV. Sent from my iPhone using Tapatalk

I'm getting into seasonal maintenance a tad late. MEP-802A is acting up a tad. The starter will kick in briefly and then stop when the switch is engaged. Dead crank has no problem engaging the starter continuously. I presume this is a bad solenoid or start relay somewhere. Where do I start...

Usually just a replacement plug. May be worth testing Ohms first. Sent from my iPhone using Tapatalk

Making more progressive toward diff centering, PS pump and water pump. Ready to pull cooling stack for access. Sent from my iPhone using Tapatalk

Yeah. Galvanic corrosion is real. Even a thin layer f corrosion protection would be an improvement. Sent from my iPhone using Tapatalk

Stripped slant back corroded armor and treating with chelation agent. Hopefully ready for paint soon. Sent from my iPhone using Tapatalk

Yep [emoji106] Distorted thread locknut Sent from my iPhone using Tapatalk

Improved X door hinge pin. Credit to Tom Rogers on this one. The pins usually bend/break at the press relief. Grade 8 5/16”x5” bolts and metal locking nuts. Assembled with locknut and thick washer. Sent from my iPhone using Tapatalk

Picked up a few parts for the 1151 at GP Chehalis WA . 120+ HMMWV in queue for auction… Sent from my iPhone using Tapatalk

Nope. Highly recommend checking for wear per TM. Sent from my iPhone using Tapatalk

Started supplemental door disassembly for rebuild. RF needs new inner skin. Sent from my iPhone using Tapatalk

Wow. Just spent 2 hours trying and failed. Struggling to get 1/4” of clearance for the caliper to crossmember. Loosening the pinion mount and a pry -bar helped but not enough. Looks like I’m pulling the cooling stack to access the mounts and recentering. Not bad, have to pull the stack anyway...

Long story, I'm WIP re-installing the front differential after a rebuild. The differential is in, RF brakes are done. I'm having difficulty with the LF caliper installation. There is not enough room in the forward direction to slip the caliper around the adapter/pads/rotor assembly. I'm...