Search results

I sure do. I have about 10 on hand at the moment.

Yes it's a SPST. Not any spst will work. In this application it has to be able to handle the current required by the four intake heaters in your 803.

Is the Emergency Off switch pulled out?

Updated my post. 🙂

Edit Prior post updated

If you are referring to the Voltage Regulator, there are no adjustments needed. I assume you didn't mean Governor Controller

Mike, Sent you a PM with purchasing details. Kurt

Yes it's a snap to install. Remove the 8 wires from the existing VR. Remove the 4 screws attaching it to the back wall. Lift it out. Secure my VR with 4 new screws that are provided. Hook the 8 wires back up to the new VR. Attach two wires from my VR. One to the Oil Pressure Gauge, one to an...

The new VR does not require the "Fuse Mod" It does not require the MOV mod. It works in generators that have defective Quad Windings. Virtually all parts are replaceable. It offers a greater output voltage adjustment range.

The replacement VR is $175 including USPS Priority Shipping to anywhere in the US including US Terratories.

I make and sell a replacement Voltage Regulator (VR) for the MEP-802A and MEP-803A. Same part for both generators. I have them in stock ready to ship.

VR is short for the A1 AC Voltage Regulator. I'm Kurt.. See the SS classifieds Parts For Sale section for the VR's

It doesn't hurt anything. It simply helps protect the A1 Voltage Regulator from shorting out.

The Varistor is not part of the official "Fuse Mod". The addition of the Varistor is done to protect the A1 Voltage Regulator from damage. The Fuse Mod only protects the Quad Winding in the gen head should the A1 VR fail and short out.

Are you looking for the original green ones? Are you ok with white bulbs?

The effort stalled about a year ago when Northern Tool stopped carrying gen heads that fit the L70. I looked around off and on and haven't found a source for a suitable head until just recently. A fellow SS member found a US source of heads for a very fair price. We just installed it on his...

For those looking to buy the connector housing and the contacts for it they are: Molex Housing P/N 0003092022 Molex Contacts P/N 0002092101 Available from DigiKey as well as many other parts suppliers

I do have two bad ones here that I'm trying to make 1 good inverter from. Both had catastrophic but different failures. My hunch about the moisture issue with the inverters is the 13 potentiometers on the main control board. The pot's aren't sealed with CC like the rest of the board is and my...

Those are insulated posts that the battery cables can be clamped to should you disconnect or remove the battery. Insulated so you can still pull start and run the generator with no battery in it (so they don't short to each other or ground)

Since you have 10 on order you could have it for the cost of shipping to you. Then when you get your 10 in just mail me one back to replace it.