Search results

Hi Is there a molle cover that works on the low back drivers seat and the high back passengers seat? My Humvee is a 91. Thanks Ken

It's supposed to be a new one. I wish there was a way to tell if it was bad. Ken

Hi It should be a simple hookup. I have voltage at the red wire and the black has a good ground. The center two wires are from the sender still no reading from the tach. I hooked the sender up to a drill and could not read any type of output. At this point I am lost. Ken

HiThe Tach I have is the one with the 4 screw terminal strip. As to the sgi-5 I don't understand how that would work, please let me know.Thanks Ken

I have installed a Tach. and like many have had no luck getting it to work. I installed it per instructions on this sight and feel everything is wired right and with continuity at all points. I bought a new sender and still no luck. Has anyone ever determined what output should come from the...

Thanks all for the inputs. It helped a lot. Ken

Hi Could someone explain what (High L ) position does? Thanks Ken

Hi When checking the voltage at the tach that you get from the fuel gauge should it be 24 volts? Ken

Hi The tach that I have is the one with the terminal stip. I used spade terminals with 18 gauge wire. I attached the power lead to the fuel gauge power wire and the ground to the ground screw on the instrument panel. The two wires to the sender, I stripped the insulation off of the wire and...

Tach still dosn't work Hi So I got a tach and It didn't work. On a previous post we thought it could be the sender so I got a new one and that didn't help. Just like before when I turn the switch to run the tach needle jumps to about one grand and then back to zero. It's like I'm not getting a...

Hi Well I got a new sender and it still will not work. When I turn on the ignition switch the pointer pounces up and then back to zero. My thinking is that I am getting power to the tach but for some reason the signal is not getting to the tach or whatever. I have hooked up a meter to the sender...

Juanprado I read 86humv's post's on this and it sounds like that is my problem also. I will check to make sure everything is wired right and that I am getting power and a good ground before I order a new sender. Thanks all for the inputs. Ken

Hi I installed a tach today and have a problem. This is the 3500 RPM tach with the terminal strip on the back. Anyway when I switch the ignition switch to run the tach will bounce up to about 1500 RPM and drop to zero right away and when I start the engine it sometimes will run up some RPM's and...

McReddy Your right, I will try to do that the next time it leaks. Thanks all for your help.\ Ken

Hi The leak isn't coming from the overflow tube. I pulled the dog house forward and could see fluid coming from the front of the engine and running down the back of the engine. My thought was the water pump but why would it only happen a couple of times? Ken

Hi I have a 1991 M998 and this has happened twice. This time I was installing a block heater. Got it in and started adding fluid. Got in about 10 quarts and the tanked topped up. So I installed the Rad. cap and after about 15 minutes of running the temp got up to about 160 and it started leaking...

Hi Looking to replace some of my flanged wheel nuts and all of my lug nuts. Half of my flanged nuts are rusty and half look like they are cad plated and cleaned up good. Need a good source for ones to replace the rusty ones. The lug nuts are rusty and I would like to replace them with the cad...

Thanks for the help . Ken

Hi Is there someplace that calls out the P/N's for the floor mats and tunnel mats? I have been trying to replace all of them from Ebay but got two that where suppose to be for the rear floor where your feet are but they where for under the seats. Also can anyone tell me what gets strapped in on...

Gays Thanks for the help. Ken