Curious old M49 fuel truck

[msgjd]

Not sure if you are referring to the centerline of the PTO output shaft? If so, the offset is less than 1/2", actually.

yes i was .. thank you for the correction !!! and post has been edited.. Been 3 years since i looked at backside of the "stripped" truck and i was 122 miles away from it when doing the post.. my pictures make it look more offset and today i was home and yep, just a whisker offset as you say .. thanks again for pointing that out promptly

 

[msgjd]

I have three questions for people who know "the real thing"
Any help here would be greatly appreciated.

Just a note that the pics Valley Rock might be posting for you of his stainless tanks are inapplicable to the gasser 1951-1963 three-compartment steel tanked M49C you wish to model , as the early steel tanks are very different from the later stainless or aluminum tanks ..

At quick glance they look similar but they have their own differences.. It would be good for him to post them so others can see the differences through the ages, but I just needed to put this tidbit here to head off any future confusion

 

[Paweł]

@msgjd - thanks a lot for the clarification! I'll pay attention to the differences!

 

[Paweł]

Hello!
I've just finished my V100 model - you can see it here:

Looking for V100 chassis pics

Very impressive! Cheers

www.steelsoldiers.com

Now I started working on my first deuce.

I cleaned up the frame rails and I made new grabhandles, to match the ones from @msgjd 's photos - the kit ones are different:

Now I would like to move on, but I'm not sure about some things... Let me show you:

What would be A61? Does it look OK for a gasser M49? How about A22 - it looks suspicious to me. I'd like to hear your comments here to correct the parts where necessary.

Thanks in advance and have a nice day

Paweł

 

[HDN]

I think A61 is supposed to be an air pack (air-assisted brake booster). A22 looks like some kind of bracket.

 

[msgjd]

What would be A61? Does it look OK for a gasser M49? How about A22 - it looks suspicious to me. I'd like to hear your comments here to correct the parts where necessary.

I concur with HDN about A61 being the booster.. Piece A22 is strange, yes there's a crossmember in that location on the real gassers, however I don't think mine has a perpendicular section on it as seen above.. You have me curious now, I will have to look at the truck again when I get home next week .. Also, the real tanks sit on a pair of U-channel brackets bolted to the frame rails, which you will see in a couple of my pictures earlier in this post

 

[gringeltaube]

That A22 would be crossmember "Z" (#7521803), here:



The longitudinal beam T-ed to that crossmember is what supports the transfer case on the drivers side. A bit confusing because there are two styles of it, this one positioned vertically.
Pictures, here...