290smallcam
Active member
- 150
- 36
- 28
- Location
- peru,indiana
I've found the size for a DT466E but not for one with the p pump. From flywheel housing to fan hub, how long is it if someone has one out laying around. One site says 42 other 45??
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
DT466 mechanical overall size?
- Thread starter 290smallcam
- Start date
- 34,012
- 1,809
- 113
- Location
- GA Mountains
Will a DT466 fit in a M35a2
Ok, i have read through some 466 threads but there not answering my question. Will the DT466 fit in the deuce engine bay? I dont want any input as far as what other engines would be a "better" transplant. I have 6bt's & ISB's but want something different. I have one 1995 DT466 w/ the inline...
www.steelsoldiers.com
- 572
- 648
- 93
- Location
- East Central Oklahoma
Near as I can tell, from the leading edge of the fan blade to the rear face of the block is about 43.5". That's not counting the bellhousing.
I assume you're trying to put a DT466 into a deuce? Please post any useful info you find! I'm planning to put one in my deuce if the multi dies. I see it talked about quite a bit, but I've never seen where it's actually ever been done.
I assume you're trying to put a DT466 into a deuce? Please post any useful info you find! I'm planning to put one in my deuce if the multi dies. I see it talked about quite a bit, but I've never seen where it's actually ever been done.
290smallcam
Active member
- 150
- 36
- 28
- Location
- peru,indiana
so with flywheel housing it'll be about 45''. Same as LDT-465. Don't think a ATAAC will fit in front of radiator. Maybe if a electric fan was used that might free up an extra inch or so?
- 572
- 648
- 93
- Location
- East Central Oklahoma
It would sure be tight to make a cooler fit. My thought was, since I wouldn't be cranking up the horsepower, it would probably be just fine without an aftercooler.
I'll try to take some more measurements when I have time, maybe this weekend.
Jeepsinker
Well-known member
- 5,399
- 456
- 83
- Location
- Dry Creek, Louisiana
The length isn't so much the problem. As long as you don't want to run an air to air intercooler, it'll fit.
The problem with the 466 swap in a deuce is the oil pan to axle clearance .
The problem with the 466 swap in a deuce is the oil pan to axle clearance .
290smallcam
Active member
- 150
- 36
- 28
- Location
- peru,indiana
Do they make a low profile pan?
topo
Well-known member
- 912
- 263
- 63
- Location
- farmington NM
The 5 tons with the Mack engine has about 1 1/4 of the top frame flange cut out to move the engine over to the right to help miss the third member . The tip fan on the multifuel is lower then the top of the valve cover and there is not much room between the hood and the valve cover the lower the fan on the DT466 the better . These are just things I have to deal with.
Jeepsinker
Well-known member
- 5,399
- 456
- 83
- Location
- Dry Creek, Louisiana
I'm not sure. A flat type pan from a generator application wouldn't be good for road use even if available. Most I've seen have really strange dual sump pans with protrusions in odd places.