Finally engine out off the M1010

[panzerwillie]

Finally got around to pull the engine out of the M1010 even do is being here for over a month when it blow up coming back from Alaska will take apart in the next few days to see what i can savage the engine only has 9000 miles after complete overhaul including new heads timing chain IP injectors balancer ect ect , for now here are some pictures of pulling it out using the wrecker

 

[Warthog]

I would say there is an issue with the oil pan....

Looking forward to the autopsy results.

 

[dstang97]

be carful with your hoist/ crane. Looks a little overloaded.

 

[southdave]

I am guessing a rod did that?? who did the overhaul?? the reason I asked, is because I just had 3 - 6.2 completely overhauled.. holy crap.. maybe I should convert all to cummins

 

[mudman]

I don't know who overhauled it....But they did not either check bearing clearance or passed up on the tork spec on the rod cap..Bummer I hope you can get your money back..Crappy job right there!!

 

[Recovry4x4]

Wasn't necessarily the builder, sometimes parts fail. Could have been pushed a little too hard in the mountains while towing as well.

 

[southdave]

Wasn't necessarily the builder, sometimes parts fail. Could have been pushed a little too hard in the mountains while towing as well.

Good point.. it took 4 motor to get enough rod for three. one of rod was bent in a shap of a U from hydro lock situation. I was amazed that it took that many.

 

[panzerwillie]

I did the overhaul my self with out taking it apart there is no saying....

 

[southdave]

Is the motor a 6.5 diesel??I see the fuel filter from one & a serp. belt set up

 

[Warthog]

Is the motor a 6.5 diesel??I see the fuel filter from one & a serp. belt set up

It is a 6.5L Turbo

 

[panzerwillie]

Yes it started as a 98 6.5 tb

 

[panzerwillie]

here u go

 

[Warthog]

It is all those yellow things that caused the problem.

Pretty clean break on the rod. That block is toast.

 

[panzerwillie]

Yes all junk cam timimg chain sprokets ect

 

[85CUCVtom]

That's a bummer. Sorry.

 

[southdave]

To quote the dude from Arkansas " I feel your pain" I ve got two motors in similar states manage to only get about 1500 mi between both motors.