• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M998 No Brake/Head/Turn/Marker Lights

FunVee

Member
15
33
13
Location
Iowa
Been troubleshooting a lighting issue on my, new to me, M998A0. Hoping the collective knowledge here can accelerate my process. Found a couple very helpful threads, linked below and been working my way through the TM's. Hopefully, one of you can point me to a common gremlin or two I can check on.

Here's what i have done. Installed new grounding harness and cleaned up all grounds it touched. Generator is charging fine. Truck starts/runs/drives fine. Dash lights, wait light and brake light work as expected. I have tried two new Tri-Switches, made zero difference. Continuity through them is fine for all positions. I have 24v at pin F on the connector to the tri switch. The tri-switch plug is clean and in good condition. I opened up the tail lights, bulbs look ok. I do not have voltage at the lights.

So far the troubleshooting is pointing met to the PCB or tri-switch. Tri-switch seems fine and PCB is giving me 24V at pin F.

Any thoughts? Thank you in advance for you help.


HMMWV A1 Troubleshooting | SteelSoldiers

m998 no lights | SteelSoldiers

HMMWV no lights at all ??? | SteelSoldiers
 

springer1981

Well-known member
844
1,150
93
Location
Maine
Been troubleshooting a lighting issue on my, new to me, M998A0. Hoping the collective knowledge here can accelerate my process. Found a couple very helpful threads, linked below and been working my way through the TM's. Hopefully, one of you can point me to a common gremlin or two I can check on.

Here's what i have done. Installed new grounding harness and cleaned up all grounds it touched. Generator is charging fine. Truck starts/runs/drives fine. Dash lights, wait light and brake light work as expected. I have tried two new Tri-Switches, made zero difference. Continuity through them is fine for all positions. I have 24v at pin F on the connector to the tri switch. The tri-switch plug is clean and in good condition. I opened up the tail lights, bulbs look ok. I do not have voltage at the lights.

So far the troubleshooting is pointing met to the PCB or tri-switch. Tri-switch seems fine and PCB is giving me 24V at pin F.

Any thoughts? Thank you in advance for you help.


HMMWV A1 Troubleshooting | SteelSoldiers

m998 no lights | SteelSoldiers

HMMWV no lights at all ??? | SteelSoldiers
Sent you a PM
 

FunVee

Member
15
33
13
Location
Iowa
Sent you a PM
Found the issue. Opened up the dash and found wire 79A, a ground, disconnected. No idea why, but someone replaced the ringeye on another ground and left this one disconnected. Cleaned up the ground screw, two other grounds, hooked them up and all the lights worked. I think one of my tail lights has an iffy ground, it flutters, but everything works. Thanks to @springer1981 for a phone call, too. He did a great job walking me through the electrical system, indirectly leading me to the fault.
Now on to the next project, the idler arm is worn. Replacing it next.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks